In this research, finite element analysis of the conventional drilling and vibration assisted drilling is carried out. The ABAQUS software is employed for FE analysis. The Johnson-Cook models for both plastic deformation and damage are employed for FE simulation.The results of the FE analysis are then verified with experimental results in both conventional and vibration assisted drilling on Al ...

In this research, finite element analysis of the conventional drilling and vibration assisted drilling is carried out. The ABAQUS software is employed for FE analysis. The Johnson-Cook models for both plastic deformation and damage are employed for FE simulation.The results of the FE analysis are then verified with experimental results in both conventional and vibration assisted drilling on Al ...

vibratory drilling (vd)process is a new modern technology where longitudinal wave with high frequency (more than 16 khz) and low amplitude (usually between 2 up to 30 µm) is superimposed on the movement of cutting tool, resulting in connection and disconnection of cutting tool engagement with workpiece. in this study, in order to perform vibratory drilling process, two vibration tools are desig...

BACKGROUND Optimal tunnel placement is critical in anterior cruciate ligament reconstructive surgery, yet the method used to drill the tunnels may compromise their placement. HYPOTHESIS An independent drilling method versus a conventional transtibial drilling method will place tunnels in different locations and produce reconstructions with different kinematics. STUDY DESIGN Controlled labor...

Bone drilling is widely used in orthopaedics and surgery; it is a technically demanding surgical procedure. Recent technological improvements in this area are focused on efforts to reduce forces in bone drilling. This study focuses on forces and a torque required for conventional and ultrasonically-assisted tool penetration into fresh bovine cortical bone. Drilling tests were performed with two...

introduction: implant bed preparation with laser is taken into consideration owing to the increased interest in use of lasers in hard tissue surgery. the purpose of this study is to determine the deviations in the position and inclination between the planned and prepared implant beds with erbium, chromium doped yttrium scandium gallium garnet (er,cr: ysgg) laser using stereolithographic (sla) s...

Deep brain stimulation (DBS) is performed by burr hole surgery. In microelectrode recording by multi-channel parallel probe, because all microelectrodes do not always fit in the burr hole, additional drilling to enlarge the hole is occasionally required, which is time consuming and more invasive. We report a stereotactic burr hole technique to avoid additional drilling, and the efficacy of this...

ultrasonic assisted drilling (usd) is new technique to drill difficult to machine materials. in this method, tool or workpiece vibrates with amplitude of few microns in addition to conventional drill bite rotation. in this experimental research, the bone was drilled both conventionally and using uad, then the thrust was measured in two methods at feed rates of 50, 75 and 125 mm/s and 500, 710 a...

objectives: implant primary stability is one of the important factors in achieving implant success. the osteotome technique may improve primary stability in patients with poor bone quality. the aim of this study was to compare implant stability using two different techniques namely osteotome versus conventional drilling in the posterior maxilla. materials and methods: in this controlled randomi...