banana samples were purchased from a local market in sabzevar located at northeast of iran. then samples stored at refrigerator between 5–10oc during experiments, for prevention of chilling injury, 36 samples at three replications were prepared so as bananas were peeled and sliced with a sharp knife at three thicknesses (3, 5 and 10 mm) and then treated by three pretreatment methods (t1: chemic...

leather manufacturing involves a crucial energy-intensive drying stage in the finishing process to remove its residual moisture. determining drying characteristics of leather is vitally important so as to optimize the drying stage. this paper describes an analytical way for determination of the drying characteristics of leather. the model presented, is based on fundamental heat and mass transfe...

Application of microwave for drying of ashwagandha roots was investigated. A laboratory convective microwave dryer was already developed which had the provision of regulating of air temperature, air velocity and microwave power. Ashwagandha roots of uniform size were used in the drying experiment which were carried out at air temperatures of 40, 50 and 60°C, air velocities of 1.0 and 1.5 m/s an...

common drying systems, including hot air convection, infrared, vacuum and ir-convective were employed to investigate and analyze the drying process of mulberry fruits. to evaluate the effect of pretreatment on the drying phenomenon, samples were pretreated by being subjected to: microwaves, chemical preparation, mechanical as well as blanching approaches. results revealed that the microwave pre...

In this study, whole lemons were dried using a laboratory convective hot air dryer and the effects of drying temperature on dehydration behaviour and mass transfer characteristics of the lemons were investigated. The drying experiments were conducted using air temperatures of 50, 60 and 75 °C and air velocity of 1 m/s. It was observed that the drying temperature affected the drying time and...

Two infrared systems set at an intensity of 4777 W/m2 with peak emission wavelengths of 2.5 and 3.5 µm were used to produce biltong by drying differently pre-treated meat. In addition to meat texture and colour, the microbial quality of the biltong produced was assessed by quantifying viable heterotrophic microorganisms using a most probable number (MPN) method and by verifying the presence of ...

Experiments were conducted on dry untreated onion shreds (2 mm thickness) or treated with salt (5% solution) and potassium metabisulphite (0.5% solution) in convective drier at 50 °C ((46±4) % relative humidity (RH)), 55 °C ((35±4) % RH), 60 °C ((28±4) % RH) and 65 °C ((20±4) % RH), heat pump-assisted convective drier at 35 °C ((32±2) % RH), 40 °C ((26±2) % RH), 45 °C ((19±2) % RH) and 50 °C ((...

In this study, a recently developed pore network drying model (Metzger et al. 2007a), which accounts for liquid viscosity, is applied to three dimensions for the first time. Isothermal convective drying is simulated for a cubic network (25×25×50) with pore throats of mono-modal radius distribution. The role of liquid viscosity is assessed by comparison with non-viscous drying of the same networ...

In this paper the kinetics of osmotic dehydration of carrot and the influence of this pretreatment on the post-drying processes and the quality of obtained products are analysed. Osmotic dehydration was carried out in the aqueous fructose solution in two different ways: with and without ultrasound assistance. In the first part of the research, the kinetics of osmotic dehydration was analysed on...

Low-cost drying technologies suitable for rural farming areas are presented. Some of the important considerations with regard to their suitability include: 1. Low initial capital; 2. easy-to-operate with no complicated electronic/ mechanical protocol, and 3. effective in promoting better drying kinetics. The drying technologies that were selected include fluidized bed, spouted bed, infrared, so...