Die corner filling is very important in tube hydroforming process. Definition of the internal pressure path is a key factor in improving the corner filling.  However, the factors that cause improvement of corner filling are still unclear. In this paper, effect of bilinear pressure path on corner filling in hydroforming of tube in box-shape die is studied using both finite element simulation and...

Drawing of square section rod from round bar can be done with two die shapes. In the first die shape, deformation starts from corners of the square and in second die shape, deformation starts from sides of square. This article has compared the drawing force for both die shapes and as a result optimum die shape was determined. Due to complexity of metal flow inside the die, analyzing of actual p...

shape error due to elastic recovery of formed part in unloading known as springback, is one of the most important problems of tool design in sheet metal forming processes. many researches have been performed for proposing an efficient method to decrease or compensate springback error in sheet forming processes. these methods are usually based on iterative finite element algorithms. in this pape...

In this paper, a generalized expression for the flow field in axisymmetric extrusion process is suggested to be valid for any dies and the boundary shapes of the plastic deformation zone. The general power terms are derived and the extrusion force is calculated by applying upper bound technique for a streamlined die shape and exponential functions for shear boundaries. It is shown that assuming...

Testentwurfsverfahren werden in die beiden Kategorien White-Box und Black-Box eingeteilt. Die Black-Box-Verfahren setzen auf der Spezifikation auf, um daraus systematisch Testfälle abzuleiten. Die White-Box-Verfahren nutzen hierfür zusätzlich den Programmtext. Oft werden beide als gleichwertig angesehen, wobei die White-BoxVerfahren eher auf den unteren Teststufen (Komponentenund Integrationste...

There are several parameters that have significant influence in metal forming process. One of the most important of them is friction coefficient. Friction can change the pattern of metal flow and the force needed for deformation. It is necessary to determine the friction coefficient to study the effect of friction on metal forming process. This study is concerned with numerical and experimental...

In this paper, an upper bound approach is used to analyze the extrusion process of bimetallic rods through arbitrarily curved dies. Based on a spherical velocity field, internal, shearing and frictional power terms are calculated. The developed upper bound solution is used for calculating the extrusion force for two types of die shapes: a conical die as a linear die profile and a streamlined di...

In this paper, an analytical method for noncircular shape extrusion is presented. Using this method, non-linear deformation field can be described with Hermit cubic spline which is prescribed by the boundary conditions of the die at its entryand exit. The upper bound method has been used to obtain optimum coefficient of the tangential boundary conditions. The results show that the optimum tange...