Inadequate hole cleaning can lead to many problems in horizontal and directional wells. In this work, we tried to investigate the cutting transport phenomenon by an experimental directional drilling simulator, considering the differences between the operational and experimental conditions. The inclination, fluid type (water, foam, viscous, and dense), rotary speed (0 and 110 rpm), nozzle bit si...

Abstract This paper explores the optimal design of cone bit nozzle diameter and a comparative analysis tooth stress. When drilling tricone bit, direct contact between roller casing wellbore is prone to wear. The fluid emitted from helps reduce friction temperature. In this paper, three-dimensional model established using software, then surface shear stress under action flow field simulated. lar...

Cavitation and turbulence in a diesel injector nozzle has a great effect on the development and primary breakup of spray. However, the mechanism of the cavitation flow inside the nozzle and its influence on spray characteristics have not been clearly known yet because of the internal nozzle flow complexities. In this paper, a comprehensive numerical simulation is carried out to study the intern...

compressible gas flow inside a convergent-divergent nozzle and its exhaust plume atdifferent nozzle pressure ratios (npr) have been numerically studied with severalturbulence models. the numerical results reveal that, the sst k–ω model give the bestresults compared with other models in time and accuracy. the effect of changes in value ofdivergence half-angle (ε ) on the nozzle performance, thru...

“The bigger they are, the harder they fall” is a bit of wisdom that’s been around for a long time. But when it comes to pesticide application, the line should read, “The bigger they are, the closer they fall.” Large droplets are not as likely to drift off-target as smaller droplets. This basic principle lies behind many innovations to reduce drift when spraying herbicides. Nozzle manufacturers ...

In the most application of nozzle with gas-liquid two-phase flow, the quality of mixture in exhaust of nozzle is the most important parameter as well as the flow velocity. On the other hand, in some industrial application, such as water injection in forced induction (turbocharged or supercharged) internal combustion engine the spray quality is the main goal of designing. In this case and for im...

Compressible gas flow inside a convergent-divergent nozzle and its exhaust plume atdifferent nozzle pressure ratios (NPR) have been numerically studied with severalturbulence models. The numerical results reveal that, the SST k–ω model give the bestresults compared with other models in time and accuracy. The effect of changes in value ofdivergence half-angle (ε ) on the nozzle performance, thru...

in this article, an algorithm for designing of a supersonic wind tunnel injection nozzle ejector is presented and based on this algorithm, a new ejector is designed for a supersonic wind tunnel. the injection nozzle consists of a volute, a nozzle, and several vanes. designed injection nozzle is simulated numerically, and the results are compared with the present injection nozzle. the results sh...