in a closed die forging process, it is impossible to form complex shapes in one stage, and thus it becomes necessary to use preform dies. in the present study, backward deformation method and fe simulation via abaqus software has been used in order to design preform die of the h-shaped parts. in the backward deformation method, the final shape of the part is considered as a starting point and u...

In a closed die forging process, it is impossible to form complex shapes in one stage, and thus it becomes necessary to use preform dies. In the present study, Backward Deformation Method and FE simulation via ABAQUS software has been used in order to design preform die of the H-shaped parts. In the Backward Deformation Method, the final shape of the part is considered as a starting point and u...

In a closed die forging process, it is impossible to form complex shapes in one stage, and thus it becomes necessary to use preform dies. In the present study, Backward Deformation Method and FE simulation via ABAQUS software has been used in order to design preform die of the H-shaped parts. In the Backward Deformation Method, the final shape of the part is considered as a starting point and u...

This paper presents a novel technique for a consistent symmetric deformable image registration based on an accurate method for a direct inversion of a large motion model deformation field. The proposed image registration algorithm maintains one-to-one mapping between registered images by symmetrically warping them to another image. This makes the final estimation of forward and backward deforma...

one of the most important parts of power transmission in automotives is c.v. joint, which consists of four components where exterior bowl is one of them. due to its complexity, and importance in automobile and existence of high stresses, forging process is the only cost effective method of production. hence, the best method of production of this part is forging process. the exterior part of c.v...

This paper presents a novel technique for a symmetric deformable image registration based on a new method for fast and accurate direct inversion of a large motion model deformation field. The proposed image registration algorithm maintain a one-to-one mapping between registered images by symmetrically warping them to each other, and by ensuring the inverse consistency criterion at each iteratio...

application of backward probability method in pollutant source tracking in non-uniform flow riversalireza ghanem.sc. student of water structures, tarbiat modares university, tehranmehdi mazaheri assistant prof., department of water structures, tarbiat modares university, tehranjamal mohammad vali samaniprofessor, department of water structures, tarbiat modares university, tehranintroductionriv...

An experimental investigation of the wall shear stress distribution downstream of a backward-facing step is carried out. The wall shear stress distribution was determined by measuring the deformation of a gel layer, attached to the wall downstream of the step. Speckle pattern interferometry was applied to measure the deformation of the gel layer. The measured deformation, combined with the prop...

in this research, the coupling between non-gray radiation and separation convection flow in a duct is investigated numerically. distributions of absorption coefficients across the spectrum  are obtained from the hitran2008 database. the full-spectrum k-distribution method is used to deal with the non-gray part of the problem, while the gray radiation calculations are performed using the planck ...