This paper describes the results of room temperature joining of TiO2 / SiO2 IRF by sputter deposition with a special emphasis of improvement of adherence at the interface. This multilayer system is designed to shield the infrared energy of solar spectrum by interference reflection. The abrasion resistance of the multilayer stacks was also estimated by the Haze value after the Taber abrasion tes...

The characterization of mixed oxides of TiO2/SiO2 and TiO2/Al2O3 prepared by sol-gel methods is described. Application of the TiO2/Al2O3 material for the photocatalytic decomposition of salicylic acid gave improved activity relative to TiO2-only materials. The photocatalytic activity of TiO2/SiO2, TiO2/Al2O3, and TiO2 toward the photocatalytic decomposition of phenol demonstrated the enhancemen...

Silicon carbide (SiC) has shown considerable potential for ultraviolet (UV) photode‐ tectors due to its properties such as wide band gap (3.26 eV for 4H-SiC), high break down electric field and high thermal stability. 4H-SiC-based UV photodetectors such as Schottky, metal-semiconductor-metal (MSM), metal-insulator-semiconductor (MIS) and avalanche have been presenting excellent performance for ...

The addition of small amounts (2-10 wt %) of SiO2 to γ-Al2O3 increases the temperature of heat treatment necessary for transformation to R-Al2O3 by ∼100 K. We have studied this system using high-temperature solution calorimetry in molten 2PbO‚B2O3 at 1043 K. Our results indicate that the spinel-type Al2O3-SiO2 solid solutions with 2-10 wt % SiO2 are always energetically metastable by 30-35 kJ‚m...

Wettability and interface microstructure were studied for Nb-containing melts in the contact with ceramic oxide materials of Al2O3-SiO2 system. Ni-40.5 at.%Nb and Au-(0-20) at.%Nb alloys were investigated as prospective alloys for high temperature brazes. Ceramic samples ranged in composition from pure Al2O3 to pure SiO2. The wettability was measured by the sessile drop method. Microstructure o...

The influence of catalyst support alumina-silica in terms of different Al2O3 to SiO2 mole ratios containing 20 wt.% Ni on the production of hydrogen and catalyst coke formation from the pyrolysis-catalysis of waste tyres is reported. A two-stage reactor system was used with pyrolysis of the tyres followed by catalytic reaction. There was only a small difference in the total gas yield and hydrog...

Nanocrystal HZSM-5 zeolite aggregates with different SiO2/Al2O3 molar ratios were prepared under low temperature and were used to catalyze the conversion of methanol to propylene and butene. The coke location, coke content, and coke species deposited on HZSM-5 aggregates were investigated. The near-graphite carbon on the external surface of HZSM-5 zeolite (SiO2/Al2O3 molar ratio = 400) was dist...

The bias stability of zinc-tin-oxide ZTO thin-film transistors TFTs with either Al2O3 gate dielectrics deposited via atomic layer deposition ALD or SiO2 gate dielectrics deposited via plasma-enhanced chemical vapor deposition PECVD was compared. Both device types showed incremental mobility 11 cm2 /V s, subthreshold slopes 0.4 V /dec, and ION / IOFF ratios of 107. During repeated ID-VGS sweepin...

The literature of olefin metathesis by heterogeneous supported catalysts, both industrial-type supported metal oxides (ReOx/Al2O3, ReOx/(SiO2−Al2O3), MoOx/SiO2, MoOx/Al2O3, MoOx/(SiO2−Al2O3), WOx/SiO2, and WOx/ (SiO2−Al2O3)) and supported organometallic complexes, is comprehensively reviewed. The focus of this Review is supported metal oxide catalysts, but the well-defined supported organometal...

Conventional supported Pt catalysts have often been prepared by loading Pt onto commercial supports, such as SiO2, TiO2, Al2O3, and carbon. These catalysts usually have simple metal-support (i.e., Pt-SiO2) interfaces. To tune the catalytic performance of supported Pt catalysts, it is desirable to modify the metal-support interfaces by incorporating an oxide additive into the catalyst formula. H...