In this paper, application of ultrasonic techniques for defect detection in weldments of austenitic stainless steel and maraging steel is discussed. Applications of ultrasonic techniques for characterizing microstructural changes in AISI type 316 stainless steel and modified 9Cr-1Mo ferritic steel; thermomechanical processing of 15Cr-15Ni-2.3Mo-titanium modified austenitic stainless steel (allo...

the aim of this study is to investigate the nucleation of new grains by necklacing mechanism during dynamic recrystallization (drx). the material used is 316 stainless steel. in order to modeling the deformation behavior during hot rolling, one-hit compression tests were performed at temperature range of 950-1100 °c with strain rates of 0.01-1s-1. the result shows that at the temperature of 100...

The corrosion resistance of type 304L and 316 austenitic stainless steels in 2M H2SO4 at 0-1.5%NaCl concentrations was studied through potentiodynamic polarization technique and optical microscopy analysis. The corrosion rate, pitting potential, passivation potential and surface morphology of both steel where significantly altered by the Clion concentration, alloy composition and metallurgical ...

An attempt made to optimize the operating parameters involved in an autogenous pulsed Nd: YAG laser welding process of similar and dissimilar combinations of butt joint of 2 mm thick 316 L stainless steel and mild steel. Influence of prominent laser welding parameters such as average peak power, defocus position, spot position, and shielding gas were investigated for welded joints considered. T...

Introduction The mechanical properties of austenitic stainless steels, including the low cyclic fatigue behavior have been a subject of numerous studies [1-8]. Nitrogen addition, in general, increases the fatigue strength by decreasing the stacking fault energy of austenitic stainless steels [6]. The stacking fault energy has a strong influence on the cross slip difficulty, thus it affects the ...

INTRODUCTION Contaminated sponges might lead to cross-contamination in kitchens since they can transfer microorganisms to surfaces where microorganisms can survive for hours or days and contaminate food. The main objective of this study was to evaluate the transfer and the survival of bacteria from kitchen sponges to surfaces of AISI 316 stainless steel and polyethylene. METHODOLOGY Twenty-fo...

A general method for brazing ceramics to metals using a compliant metallic foam as a buffer layer has been developed. Using stainless steel foams, bonds between alumina and 316 stainless steel with shear strengths up to 33 MPa have been achieved. The resultant ductility enhances the resistance of the joint to thermal cycling; AlN-Inconel 600 bonds exhibited good thermal shock resistance. Alumin...

The influence of the concentration of1-H-benzoteriazolon the corrosion of 316 stainless steel (SS) in chloride acid 1M solutions was studied. The potentiodynamics polarization and scanning electron microscopy (SEM) have been used. The inhibition efficiency increased with an increase in the concentration of1-H-benzoteriazol.The adsorption of1-H-benzoteriazol onto the SS surface occurs accord...

Heterotrophic bacteria (11 genera, 14 species, 25 putative strains) were isolated from drinking water, identified either biochemically or by partial 16s rDNA gene sequencing and their adherence characteristics were determined by two methods: i. thermodynamic prediction of adhesion potential by measuring hydrophobicity (contact angle measurements) and ii. by measuring adherence to eight differen...

The evaporation of inertial confinement fusion first wall materials from unattenuated pellet X-rays and from radiation emitted by a cavit.y buffer qas is examined. The low vapor pressure and low X-ray attenuation coefficient of carbon give it a lower erosion rate than stainless steel, despite the larger thermal conductivity of Type 316 stainless steel. For the argon buffer gas containing 0.2% N...