This study reveals the effect of TiB₂ particles on the mechanical and tribological properties of Fe₃Al-TiB₂ composite coatings against an alumina counterpart. The feedstock was produced by milling Fe₃Al and TiB₂ powders in a high energy ball mill. The high-velocity oxy-fuel (HVOF) technique was used to deposit the feedstock powder on a steel substrate. The effect of TiB₂ addition on mechanical ...

Friction and wear are part and parcel of all walks of life, and for interfaces that are in close or near contact, tribology and mechanics are supremely important. They can critically influence the efficient functioning of devices and components. Nanoscale friction force follows a complex nonlinear dependence on multiple, often interdependent, interfacial and material properties. Various studies...

For last several decades aluminium and aluminium alloys are widely used in automotive industries because for their favourable properties like low density (about 2700 Kg/m 3 ), good malleability, high formability, high corrosion resistance and high electrical and thermal conductivity. High machinability and workability of aluminium alloys are prone to porosity due to gases dissolved during melti...

The mechanical and tribological properties of electrospun fiber mats are of paramount importance to their utility as components in a large number of applications. Although some mechanical properties of these mats have been reported previously, reports of their tribological properties are essentially nonexistent. In this work, electrospun nanofiber mats of poly(trimethyl hexamethylene terephthal...

In the current research work synthesis, characterization, mechanical and wear behavior of 5 and 10 wt. % of nano TiO2 particulates reinforced Al7075 alloy composites are inspected. The Al7075 alloy and nano TiO2 particle composites were provided by melt stir system. After the preparation, the prepared composites were analyzed by SEM, EDS, and XRD for inquiring the microstr...

The objectives of this research were to find an economical way of reducing porosities in the microstructure of coatings deposited by flame spraying technique on CK45 steel and also trying to increase their cohesive strength to the substrate, so that the overall wear properties of this type of coating can be improved. So several specimens from this steel coated with NiCrBSi powder under specific...

In this study, the hardness and wear behaviour of carburized and boronized AISI 8620 steels have been studied. The boronizing treatment increased the hardness of AISI 8620 steels from 395 HV0.1 to a maximal 1610 HV0.1 compared to the carburized steels and also significantly improved its wear behaviour. From obtained results, it can be concluded that boronizing is very effective surface hardenin...

The friction and wear properties of graphene and graphene oxide (GO) with varying C/O ratio were investigated using friction force microscopy. When applied as solid lubricants between a sliding contact of a silicon (Si) tip and a SiO2/Si substrate, graphene and ultrathin GO films (as thin as 1-2 atomic layers) were found to reduce friction by ∼6 times and ∼2 times respectively as compared to th...

In order to further enhance tribological properties 316 Low carbon stainless steel (L SS) used on mechanical parts. CrN/TiN with DC magnetron sputtering sources was carried out on PVD 316 L SS. The micro structure of the CrN/TiN coatings were investigated by Scanning electron microscope (SEM), X-ray Diffraction (XRD) and tribology properties were investigated on a Pin on Disc friction and wear ...

in this research, al-ni particle composite strips are formed by accumulative roll bonding (arb) process using al strips and ni powder. the rule of arb cycles and volume percentage (vol%) of ni powder on the microstructure, wear resistance and mechanical properties of the formed composites are investigated. according to the tensile test results, the yield stress and tensile strengths of the al -...