The purpose of this paper is to describe a model predictive direct torque control (MPDTC) with load angle limitation for surface-mounted permanent magnet synchronous motor (SPMSM) drive system. In this paper, an exact discrete-time state-space model of SPMSM is presented, which improves the state prediction accuracy comparing to simple Euler approximation. A finite control set type MPDTC is use...

In this paper, a generalized discontinuous pulsewidth modulation (GDPWM) method with superior high modulation operating range performance characteristics is developed. An algorithm which employs the conventional space-vector PWM method in the low modulation range, and the GDPWM method in the high modulation range, is established. As a result, the current waveform quality, switching losses, volt...

The present work describes an optimal operation of a small scale photovoltaic system connected to a micro-grid, based on both sliding mode and fuzzy logic control. Real time implementation is done through a dSPACE 1104 single board, controlling a boost chopper on the PV array side and a voltage source inverter (VSI) on the grid side. The sliding mode controller tracks permanently the maximum po...

In order to supply power from a solar panel or photo voltaic system at a low voltage to a grid at high voltage, a power electronic converter which is capable of voltage boosting and inversion is required. Newly introduced Switched Boost Inverter is capable of achieving both these objectives by a single stage. This paper presents a PWM control strategy based switched Boost Inverter (SBI) for DC ...

This paper presents an integrated power factor correction (PFC) buck-boost buck converter based voltage source inverter (VSI) fed brushless DC motor (BLDC) drive using a single voltage sensor. The speed is controlled by controlling the DC bus voltage of the VSI. An electronic commutation of the BLDC motor is used which utilizes a fundamental frequency switching (FFS) of VSI which in-turn offers...

In this paper, a buck half-bridge DC-DC converter is used as a single-stage power factor correction (PFC) converter for feeding a voltage source inverter (VSI) based permanent magnet brushless DC motor (PMBLDCM) drive. The front end of this PFC converter is a diode bridge rectifier (DBR) fed from single-phase AC mains. The PMBLDCM is used to drive a compressor load of an air conditioner through...

As a basic building block in power systems, the three-phase voltage-source inverter (VSI) connects the distributed energy to the grid. For the inductor-capacitor-inductor (LCL)-filter three-phase VSI, according to different current sampling position and different reference frame, there mainly exist four control schemes. Different control schemes present different impedance characteristics in th...

In this paper, A power factor correction (PFC) based single ended primary inductor converter (SEPIC) is used to regulate DC bus voltage of voltage source inverter (VSI) to run PMBLDC motor . Permanent magnet brushless DC motor (PMBLDCM) is used in air-conditioning systems and runs at rated torque and variable speed to achieve energy conservation. The analysis, design and performance of the prop...

In this paper, a novel and simple control strategy, based on state feedback method is suggested to control the power injection system (PIS). The considered PIS is composed of, a DC voltage source, a voltage source inverter (VSI) and a L-C-L filter. The DC source includes the battery source with boosted voltage. The battery can be charged with photovoltaic cells. Since, the grid voltage acts as ...

The aim of this project is to model a six step discontinuous current mode inverter fed to a Permanent Magnet Synchronous Motor (PMSM) drive using MATLAB/SIMULINK. The dq-axis Voltage-Current and Torque relation in terms of machine parameters are used along with a six step 120 degree mode inverter and gate drive using MATLAB/SIMULINK. There is also a provision for easy changes to the machine par...