Rapid heat cycle molding (RHCM) is a special molding process capable of producing molded plastic parts with high surface quality and improved weldline strength and appearance. This study investigated the influence of the weldline on the tensile strength of RHCM and conventional injection molded (CIM) components. The test specimens with and without a weldline were cut from RHCM and CIM parts for...

It is commonly proposed that the fatigue strength can be enhanced by increasing the tensile strength, but this conclusion needs to be reconsidered according to our study. Here a recrystallized α-Cu-15at.%Al alloy with moderate grain size of 0.62 μm was fabricated by cold rolling and annealing, and this alloy achieved exceptional high fatigue strength of 280 MPa at 10(7) cycles. This value is mu...

Using molecular dynamics we find that the tensile strength of the contacts between two clean platinum surfaces with nanoscale asperities is strongly size dependent with a maximum strength for contact lengths of approximately 5 nm. This is the first time a strongest size is observed in single crystals. The strengthening with decreasing size down to 5 nm results from a decrease in the initial den...

A three-dimensional (3D) representative volume element (RVE) model was developed for analyzing effective mechanical behavior of fiber-reinforced ceramic matrix composites with imperfect interfaces. In the model, the fiber is assumed to be perfectly elastic until its tensile strength, and the ceramic material is modeled by an elasto-plastic Drucker-Prager constitutive law. The RVE model is then ...

The effects of zein ratio, concentration of glycerol, liquid-solid ratio, ethanol concentration, pH and heat-treatment temperature on the properties of zein/wheat gluten composite films were researched. The results showed that elongation (E) increased with an increase in glycerol or ethanol concentrations, but it first increased and then decreased with increasing zein/wheat gluten ratio, heat-t...

The transfer of surface-generated meltwater to the subglacial drainage system through full ice thickness crevassing may lead to accelerated glacier velocities, with implications for ice motion under future climatic scenarios. Accurate predictions of where surface meltwater accesses the ice/bed interface are therefore needed in fully coupled hydrodynamic ice-sheet models. We present a spatially ...

High-entropy alloys (HEAs) can have either high strength or high ductility, and a simultaneous achievement of both still constitutes a tough challenge. The inferior castability and compositional segregation of HEAs are also obstacles for their technological applications. To tackle these problems, here we proposed a novel strategy to design HEAs using the eutectic alloy concept, i.e. to achieve ...

A Fe-20.1Mn-1.23Si-1.72Al-0.5C TWIP steel with ultra-fine grain structure was successfully processed through Equal Channel Angular Pressing (ECAP) at warm temperature up to four passes following the BC route. The microstructure evolution was characterized by Electron Back Scattered Diffraction (EBSD) to obtain the grain maps, which revealed an obvious reduction of grain size, as well as a decre...

[Purpose] The aim of this study was to verify how the application of elastic tape to the anterior surface of the thigh changes the knee angle pattern during gait. [Subjects] The subjects were 10 people who showed an abnormal knee angle change pattern during usual walking. They did not show the so-called double knee action. [Methods] Subjects were asked to walk as usual, and then to walk with el...

The internal pressure strength of tubing and casing often cannot satisfy the design requirements in high pressure, high temperature and high H2S gas wells. Also, the practical safety coefficient of some wells is lower than the design standard according to the current API 5C3 standard, which brings some perplexity to the design. The ISO 10400: 2007 provides the model which can calculate the burs...