recently, bulk nano-structured materials produced by severe plastic deformation (spd) have attracted scientists attention.  materials produced by spd are of great importance because of (1) non-porous structure, (2) great mechanical properties such as high strength and toughness and (3) proper dimension for mechanical and physical testing.  several methods have been introduced for imposing the s...

The influence of loading rate (crosshead speed) on the fracture process of bluntly notched samples of pearlitic steel under hydrogen environment is analyzed in this paper. Results indicate that the location of the zone where fracture initiates (fracture process zone) in pearlitic steel samples with a blunt notch directly depends on the loading rate or crosshead speed. For slow testing rates, su...

The aim of this paper is to present results of testing a full scale reinforced concrete T connection by static loading. The connection represents a beam-column connection. The beam and column had a square cross section with a 300 mm dimension. The height of the column was 2.9 m and the clear beam length was 1.4 m. The connection was initially tested to failure. Galvanised steel straps were used...

Tensile and creep properties of new austenitic steel Sanicro 25 at room temperature and operating temperature 700 °C were investigated by testing on miniature specimens. The results were correlated with testing on conventional specimens. Very good agreement of results was obtained, namely in yield and ultimate strength, as well as short-term creep properties. Although the creep rupture time was...

Pulsed eddy current inspection techniques were derived from the conventional eddy current testing technology, based on the fundamental principle of an eddy current coil, but using periodic ultrasound pulses. The authors first introduce the principle of pulsed eddy current inspection and some experimental measurement results using pulsed eddy current equipment. This technology can be applied to ...

Disinfectants play an important role in controlling microbial contamination on hard surfaces in hospitals. The effectiveness of disinfectants in real life can be predicted by laboratory tests that measure killing of microbes on carriers. The modified Quantitative Disk Carrier Test (QCT-2) is a standard laboratory method that employs American Iron and Steel Institute (AISI) Type 430 stainless st...

Godrej Security Solution Division has developed bullet resistant solutions like Bullet resistant doors, Mantraps, Bullet resistant screening for banks, and bullet resistant cabins etc which are designed as per the requirements mentioned in various standards like National institute of Justice (NIJ), Underwriters Laboratory (UL), etc. These agencies have established the performance criteria and c...

In recent years, there has been increased discussion of the strength of vehicle roofs in rollover crashes. NHTSA recently revised the federal roof strength requirement and the IIHS has published an even more stringent roof strength goal. While working to increase roof strength, automakers are also working to reduce vehicle mass for improved fuel economy and other benefits. Developing technology...

The purpose of this research is to determine the feasibility of developing a new aesthetic, crashworthy terminal for the steel-backed timber (SBT) guardrail system for use by the National Park Service and others along park roads and scenic highways. Two conceptual designs, a flared non-energy absorbing concept and a parallel energy absorbing concept, were developed using the same materials that...

Non-Destructive testing is useful in rail, pipeline and aerospace industries for maintenance of equipment, such as thickness measurements, corrosion and defect detection in materials. In this work a finite element analysis of an Electromagnetic acoustic transducer is presented. EMAT is an emerging technology that provides a non contact process of testing materials compared to ultrasonic sensors...