In nuclear power plants, the main corrosion product that is deposited on the outside of steam generator tubes is porous magnetite. The objective of this study was to simulate porous magnetite that is deposited on thermally treated (TT) Alloy 690 steam generator tubes. A magnetite layer was electrodeposited on an Alloy 690TT substrate in an Fe(III)-triethanolamine solution. After electrodepositi...

Achieving accurate control of main steam temperature is a very difficult task in thermal power plants due to the large process lag (8 to 10 minutes) associated with the superheater system and there exists a deviation of ± 10 °C in closed loop control. A control oriented boiler model and an appropriate optimal control strategy are the essential tools for improving the accuracy of this control sy...

In this paper, an improved system to efficiently utilize the low-temperature waste heat from the flue gas of coal-fired power plants is proposed based on heat cascade theory. The essence of the proposed system is that the waste heat of exhausted flue gas is not only used to preheat air for assisting coal combustion as usual but also to heat up feedwater and for low-pressure steam extraction. Ai...

In the marine steam power plant, the main boiler has the small size and the little heat capacity. However, marine ship requires high maneuverability, when it is running, the loads varied frequently, and the varying range is big, and this will cause the boiler security problem, such as over-pressure or under-voltage. The marine steam power plant boilerturbine coordinated control strategy is to s...

This work presents a simulation study on both energy and economics of power generation plants with inherent CO2 capture based on chemical looping combustion technologies. Combustion systems considered include a conventional chemical looping system and two extended three-reactor alternatives (exCLC and CLC3) for simultaneous hydrogen production. The power generation cycles include a combined cyc...

Process cooling below ambient temperature is an energy demanding part of many chemical production processes. Compression refrigeration systems operating at very low temperatures consume a lot of high quality utility such as electricity or high pressure steam to drive the compressor units. In industrial process clusters with several processes operating at low temperatures, it is important to inv...

Combined heat and power systems are becoming more and more important, regarding their enhanced efficiency, energy saving, and environmental aspects. In the peresent study, three configurations of combined heat and power systems are intended as an alternative to separate production plant by considering environmental aspects. First and second laws of thermodynamics are adapted to the operatin...

While efficiency is still the major driver in combined cycle power plant design, there is an increasing need for operational flexibility along with additional operating cost reduction. nightly and weekend shutdowns and subsequent start-up capabilities should be considered during the overall evaluation of a power plant. Technological advancements in power plant design involving gas and steam tur...

The Pulverize is a major part of the boiler combustion system and an important part in the system of steam power plant (PLTU). Pulverizer plant serves to break chunks of coal into the coal ash was then fed to the burner. Type of feed coal into a pulverize is cleaned with a value product pulverize optimum 30%. The percentage of this value greatly affects the production of steam in the boiler. Th...