Steam-induced vibration is a kind of self-excited vibration which is one of the most important issues affecting the operation reliability of steam turbines. A lot of actual cases of steam-induced vibration of steam turbine were collected in this work. And steam-induced vibration fault was statistical and classified by fault reason, happened time, occurrence load and fault severity. The statisti...

The boiler drum level control unit is one of the main parameter in the thermal power station. Currently the boiler drum parameters are monitored only by using MATLAB software. There is no automatic control available. In the proposed system the boiler drum parameters such as temperature level, pressure level, water level and Droplet identifier are measured and controlled by using embedded proces...

Energy saving potentials related to steam generation and its usage in the medium size bakery are analyzed presented. Input data needed for investigation gathered through detailed energy audit. Four savings measures analysed detail: 1) change of heat generator space heating domestic hot water preparation from boiler condensing boiler, 2) reduction losses condensate distribution lines, 3) utiliza...

Understanding and modeling of three-phase transient flow in gas-condensate wells play a vital role in designing and optimizing dynamic kill procedure of each well that needs to capture the discontinuities in density, geometry, and velocity of phases but also the effect of temperature on such parameters. In this study, two-phase Advection-Upstream-Splitting-Method (AUSMV) hybrid scheme is extend...

PURPOSE To compare PRESS and STEAM MR spectroscopy for assessment of liver fat in human subjects. MATERIALS AND METHODS Single-voxel (20 x 20 x 20 mm) PRESS and STEAM spectra were obtained at 1.5T in 49 human subjects with known or suspected fatty liver disease. PRESS and STEAM sequences were obtained with fixed TR (1500 msec) and different TE (five PRESS spectra between TE 30-70 msec, five S...

[1] Steam explosions, or littoral blasts, generated when pyroclastic flows interact with seawater may be a common, although rarely documented, phenomena. The development of steam explosions rather than passive steam production is related to the rate of thermal energy transfer from hot pyroclasts to water. We conduct a series of laboratory experiments to quantify the heat transfer and steam prod...

In power station practice, work is extracted from expanding steam in three stages namely High Pressure(HP), Intermediate Pressure(IP) and Low Pressure(LP) turbines. During the expansion process in the LP turbine, the steam cools down and at some stages, it nucleates to become a two-phase mixture. It is well-acknowledged in the literature that the nucleating and wet stages in steam turbines are ...

Steam-water flow exists in most geothermal reservoirs where steam-water capillary pressure plays an important role in controlling fluid distribution, transfer of liquid between fracture and matrix, well productivity, and even the reserves. However, it is very difficult to measure steam-water capillary pressure due to the phase transformation and the significant mass transfer between the two pha...

constructing phase diagram and its subsequent quality lines for lean gas condensate reservoirs is always crucial and challenging topic in reservoir fluid studies. due to small amounts of liquid drop-outs in lean gas condensates at reservoir conditions, full experimental tracking of phase diagram and its relevant quality lines is almost impossible for lean gas condensates.on the other hand, eos ...

In this paper, Steam Assisted Gravity Drainage (SAGD) is introduced and its advantages over ordinary steam injection is demonstrated. A simple simulation model is built and three scenarios of natural production, ordinary steam injection, and SAGD are compared in terms of their cumulative oil production and cumulative oil steam ratio. The results show that SAGD can significantly enhance oil prod...