The ability to strongly absorb light is central to solar energy conversion. We demonstrate here that the hybrid of monolayer ZrS2 and double-ring tubular B20 cluster exhibits dramatically enhanced light absorption in the entire visible spectrum. The unique near-gap electronic structure and large built-in potential at the interface will lead to the robust separation of photoexcited charge carrie...

A dye-sensitized solar cell (DSC) has unique properties that the cell performance does not readily decrease even at higher incident light angles compared with a Si solar cell and dose not decrease or rather increases under low light conditions. Fujikura is developing new applications of DSC by taking advantages of these properties to the field of “Energy Harvesting” where rapid growth of market...

Ti3+ species are highly unstable in air owing to their facile oxidation into Ti4+ species, and thus they cannot concentrate in the surface layer of TiO2 but are mainly present in its bulk. We report generation of abundant and stable Ti3+ species in the surface layer of TiO2 by boron doping for efficient utilization of solar irradiation. The resultant photocatalysts (denoted as B-TiO2-x) exhibit...

In this paper, a zinc oxide (ZnO) nanotube, fabricated by the hydrothermal growth method on triple-junction (T-J) solar cell devices to enhance efficiency, is investigated. Compared to those of bare T-J solar cells (without antireflection (AR) coating) and solar cells with Si3N4 AR coatings, the experimental results show that the T-J solar cells, which use a ZnO nanotube as an AR coating, have ...

This paper illustrates the possibility of measuring chlorophyll (Chl) content and Chl fluorescence parameters by the solar-induced Chl fluorescence (SIF) method using the Fraunhofer line depth (FLD) principle, and compares the results with the standard measurement methods. A high-spectral resolution HR2000+ and an ordinary USB4000 spectrometer were used to measure leaf reflectance under solar a...

Manipulating the flow of energy in nanoscale and molecular photonic devices is of both fundamental interest and central importance for applications in light energy harvesting optoelectronics. Under erratic solar irradiance conditions, unregulated power fluctuations in a light-harvesting photocell lead to inefficient energy storage in conventional solar cells and potentially fatal oxidative dama...

In this paper, I discuss a brief history of waveguide technologies, followed by a derivation of the behavior of light in a cylindrical dielectric. The cutoff conditions and an expression relating wavelength modes and wavelength radius will be derived. Next, the effectiveness of nanowire thin films as waveguides for increasing light trapping in solar cells will be discussed. Experimental results...

Overall performance of a thin film solar cell is determined by the efficiency of converting photons to electrons through light absorption, carrier generation, and carrier collection. Recently, photon management has emerged as a powerful tool to further boost this conversion efficiency. Here we propose a novel nanograting solar cell design that achieves enhanced broadband light absorption and ca...

The influence of the interface morphologies on amorphous silicon thin-film solar cells prepared on randomly textured substrates was studied. A simple three-dimensional geometrical model was developed to describe the surface morphology of amorphous silicon films and thin-film solar cells. The simulated surface morphologies are confirmed by experimental measurements. A detailed understanding of t...

In 1982, Yablonovitch proposed a thermodynamic limit on light trapping within homogeneous semiconductor slabs, which implied a minimum thickness needed to fully absorb the solar spectrum. However, this limit is valid for geometrical optics but not for a new generation of subwavelength solar absorbers such as ultrathin or inhomogeneously structured cells, wire-based cells, photonic crystal-based...