In this article, we report an improvement in the pH sensitivity of low-temperature polycrystalline-silicon (poly-Si) thin-film transistor (TFT) sensors using an H2 sintering process. The low-temperature polycrystalline-silicon (LTPS) TFT sensor with H2 sintering exhibited a high sensitivity than that without H2 sintering. This result may be due to the resulting increase in the number of Si-OH2(...

ncorporating Ni-laden waste sludge into kaolinite-based construction ceramic materials appears promising based on the identified nickel bearing hases, evaluated incorporation efficiency and nickel leachability of the products. Nickel aluminate spinel (NiAl2O4) results from sintering kaolinite nd nickel oxide between 990 and 1480 ◦C, with more than 90% incorporation efficiency achieved at 1250 ◦...

Lead free potassium sodium niobate (KNN) piezoceramics were synthesized via conventional solid state sintering route. Nano and micron WO3 were separately added to KNN through ball-milling. Dielectric and piezoelectric properties of samples sintered in the temperature range of 1110°-1145°C were measured by precision LCR-meter and APC d33-meter devices. The results revealed that micron WO3 partic...

The usage of powder metallurgy aluminium compacts in lieu of ferrous components in automotives helps to lower vehicle weight. The major drawback in the commercially available press sintered aluminium alloy is porosity which is mainly dependent on the powder metallurgical process parameters such as compaction pressure, sintering temperature and cooling rate after sintering. In this paper the eff...

Lightweight aggregate (LWA) production with sewage sludge and municipal solid waste incineration (MSWI) fly ash is an effective approach for waste disposal. This study investigated the stability of heavy metals in LWA made from sewage sludge and MSWI fly ash. Leaching tests were conducted to find out the effects of MSWI fly ash/sewage sludge (MSWI FA/SS) ratio, sintering temperature and sinteri...

synthesized using the conventional solid-state reaction method at 1350–1550°C in air in order to investigate the effect of dopants on sintering, crystal structure, chemical stability under CO2 and H2S, and electrical transport properties. The formation of the single-phase perovskite-type structure with an orthorhombic space group Imam was confirmed by Rietveld refinement using powder X-ray diff...

The potential of a combination between single-step sintering and ZrO2 additive as a simple ceramic fabrication method to obtain dental porcelain-based ceramic-nanocomposites with good mechanical properties was demonstrated. Influences of sintering condition on phase formation, densification, microstructure and mechanical properties of these porcelain ceramics were examined via XRD, SEM-EDX and ...

Functional energy storage and return prosthetic and orthotic devices have been manufactured out of Nylon 11 using selective laser sintering due to its high ductility and energy return properties. However, there is concern that material voids caused by incomplete sintering may compromise material properties and lead to premature fracture. Post-build annealing has the potential to eliminate voids...

Si3N4/BN fibrous monoliths were prepared with 4 wt% Y2O3 added as a sintering aid to the Si3N4. Residual carbon, present in the billet before hot-pressing, was shown to influence the final microstructure. The sintering aid glass, known to migrate into the BN cell boundaries during hotpressing, was not sufficient in quantity to prevent premature shear failure when samples were tested in flexure....

Al–TiC nanocomposite materials have been prepared by a new in situ synthesizing technique. A mixture of aluminum, titanium, and graphite has been prepared using ball milling technique and then melted in a high frequency induction heat furnace (HFIHF) at different sintering temperatures, namely 900, 1100, and 1300 °C. The effect of sintering temperature on the corrosion of the Al–TiC composite i...