present research involves the complete simulation of pultrusion manufacturing process of glass/polyester composites. for that purpose, the curing process is divided to two liquid and gel-solid phases. the physical characteristics of the resin consist of specific heat, viscosity and coefficient of heat transfer changes with variations of temperature and increasing the degree of curing process (α...

The purpose of this study was to analyze the curing behavior of a nanocomposite by assessing in real time the degree of cure at depths of 2 mm and 6 mm. The variation of hardness with depth, shrinkage stress, and curing time until gelation with 16 curing regimes was further investigated using one halogen and three LED curing units. In the present study, it was shown that the soft-start polymeri...

PURPOSE The objective of this study was to compare the light transmittance of zirconia in different thicknesses using various light curing units. MATERIALS AND METHODS A total of 21 disc-shaped zirconia specimens (5 mm in diameter) in different thicknesses (0.3, 0.5 and 0.8 mm) were prepared. The light transmittance of the specimens under three different light-curing units (quartz tungsten ha...

This data article provides a comparison data for nano-cement based concrete (NCC) and ordinary Portland cement based concrete (OPCC). Concrete samples (OPCC) were fabricated using ten different mix design and their characterization data is provided here. Optimization of curing time using the Weibull distribution model was done by analyzing the rate of change of compressive strength of the OPCC....

introduction: discoloration of resin composites is a common reason for replacement of these restorations. the aim of this study was to eva-luate the influence of different light curing de-vices on color stability of a microhybrid resin composite. materials and methods: 80 disc-shaped speci-mens (8 mm in diameter, 2-mm height) were fabricated from filtek z250 resin composite. specimens were divid...

To reduce the labor cost and the workload required in the tobacco curing process, an intelligent tobacco curing control technique adopting color identification of the tobacco leaves is proposed. The HSI color space is used in color segmentation and the color recognition with fuzzy decision is used in the curing process. The curing controller can identify the curing stage by the color features o...

The effect of curing agent (6610) content and temperature on the rheological behavior of the epoxy resin CYD-128 was studied by DSC analysis and viscosity experiments. The results show that the resin system meets the requirements of processing technology. A complete reaction occurs when the curing agent content (40 parts per hundred resin, phr) is a little higher than the theoretical value (33....

Flue-curing is a post harvest conditioning process which strongly affects the tobacco leaf chemistry, and consequently the chemical properties of tobacco smoke. Several studies identified the major changes in tobacco chemistry occurring during flue-curing. It is not known how flue-curing contributes to changes in bioactivity of cigarette smoke condensate (CSC). In this study, tobacco leaves col...