cooling towers are widely used in most industrial units to reject waste heat to the atmosphere. this paper deals with an experimental analysis of heat and mass transfer phenomena between water and air by direct contact in a cooling tower. the tower is filled with 6 type packing. in this study temperature and pressure drop and tower characteristics was used in determining experimentally the ther...

In this research, heat transfer enhancement and simultaneous effect of that on pressure drop inside condensers with twisted tape inserts are investigated. A refrigeration system is designed for attaining to maximum level of heat transfer with minimum pressure drop. The test condenser is a double pipe heat transformer with inner and outer diameter of 10.7mm and 12.7mm for internal pipe, respecti...

In this paper, the boundary-based estimation of pressure distribution in the cardiovascular system is investigated using two dimensional flow images. The conventional methods of non-invasive estimation of pressure distribution in the cardiovascular flow domain use the differential form of governing equations. This study evaluates the advantages of using the integral form of the equations in the...

In this paper, the boundary-based estimation of pressure distribution in the cardiovascular system is investigated using two dimensional flow images. The conventional methods of non-invasive estimation of pressure distribution in the cardiovascular flow domain use the differential form of governing equations. This study evaluates the advantages of using the integral form of the equations in the...

a new correlation function for the calculation of viscosity for five typical supercritical gases is presented using the rainwater-friend and modified enskog theory. it is shown that by using accurate value for the thermal pressure and co-volume in the modified enskog theory, this correlation function is suitable for calculation of the viscosity of supercritical gases, without any density and te...

A method to determine the economic cost of gas turbine compressor fouling was developed. The method is based on the calculation of the influence of the drop of compressor performances (isentropic efficiency, pressure ratio and air mass flow) on Heat Rate and full load power of the gas turbine. A statistical procedure to quantify the drop of compressor performances with fouling and to obtain amb...

A numerical model is developed to simulate the transport phenomena in the flow channel between parallel plates with porous and non-porous (or impermeable) walls. The continuity and momentum equations were solved first, assuming the wall Reynolds number in the range of with the suction or injection of air at a speed equal to the uniform inlet velocity. The results show that at constant inlet and...

In this study, the convective heat transfer and pressure drop in laminar flow of Al2O3/water and CuO/water nanofluids through square and triangular cross-sectional ducts have been numerically investigated using new technique. It has been assumed that there is constant heat flux boundary condition at walls. In addition, to include the presence of nanoparticles, the dispersion model has been used...