Experimental investigations of heat transfer coefficient of CuO/Water nanofluid are reported in this paper. The heat transfer coefficient of the CuO/water was measured with the help of double pipe heat exchanger. The nanofluid was prepared by dispersing a CuOnano particle in deionized water. CuO/water nanofluid with a nominal diameter of 27nm at different volume concentrations (0.1 &0.3 vol.%) ...

A two-phase flow experiment using air and water-based γ-Al2O3 nanofluid was conducted to observe the basic hydraulic phenomenon of nanofluids. The local two-phase flow parameters were measured with a conductivity double-sensor two-phase void meter. The void fraction, interfacial velocity, interfacial area concentration, and mean bubble diameter were evaluated, and all of those results using the...

This study analyzes the characteristics of alumina (Al2O3)/water nanofluid to determine the feasibility of its application in an air-cooled heat exchanger for heat dissipation for PEMFC or electronic chip cooling. The experimental sample was Al2O3/water nanofluid produced by the direct synthesis method at three different concentrations (0.5, 1.0, and 1.5 wt.%). The experiments in this study mea...

Nanofluids are liquids containing suspensions of solid nanoparticles and have attracted considerable attention because they undergo substantial mass transfer and have many potential applications in energy technologies. Most studies on nanofluids have used low-ionic-strength solutions, such as water and ethanol. However, very few studies have used high-ionic-strength solutions because the aggreg...

This article mainly concerns theoretical research on entropy generation influences due to heat transfer and flow in nanofluid suspensions. A conventional nanofluid of alumina-water (Al2O3-H2O) was considered as the fluid model. Due to the sensitivity of entropy to duct diameter, miniand microchannels with diameters of 3 mm and 0.05 mm were considered, and a laminar flow regime was assumed. The ...

It is necessary to control the temperature of solar cells for enhancing efficiency with increasing concentrations of multiple photovoltaic systems. A heterogeneous two-phase model was established after considering the interacting between temperature, viscosity, the flow of nanofluid, and the motion of nanoparticles in the nanofluid, in order to study the microchannel heat sink (MCHS) using Al2O...

A theoretical analysis of the influence temperature and nanoparticle concentration on free convection heat transfer from a horizontal tube immersed in an unbounded nanofluid was presented. The Nusselt (Nu) number coefficient were parameters intensity convective transfer. For convection, Nu function Rayleigh (Ra) Prandtl (Pr) number. functions thermophysical properties nanofluids. nanofluids var...

The objective of this research is to examine the steady incompressible two-dimensional hydromagnetic boundary layer flow nanofluid passing through a stretched sheet in influence viscous and ohmic dissipations. present problem obtained with help an analytical technique called DTM-Pade Approximation. mathematical modeling considered form partial differential equation transformed into suitable sim...

The heat and mass transfer simulation of magnetohydrodynamics (MHD) radiative convective flow nanofluid through an inclined porous surface are studied. governing system couple partial differential equations transformed into a ordinary equations. This transformation is done by similarity technique. numerical solutions sixth order Runge-Kutta method along with Nachtsheim-Swigert shooting iteratio...

Numerical simulation and experimental investigation were used for study of laminar forced convective heat transfer of Al2O3/water nanofluid. Single phase model with temperaturedependent properties was employed for numerical simulation of transport phenomena in nanofluid. The results of experiments and computer-aided simulation indicated remarkable enhancement of convective heat transfer of base...