Turbochargers are most widely used in automotive, marine and locomotive applications with diesel engines. To increase the engine performance nowadays, in aerospace applications also turbochargers are used. Mostly the turbocharger rotors are commonly supported over the fluid film bearings. With the operation, lubricant properties continuously alter leading to different load bearing capacities. T...

Hydroprocessing has become the main technology for the production of API Group II and III base oils. One of the key properties is viscosity index for Group II and III base oils. The effect of wax content in hydrocracker unconverted oil on viscosity index and yield was studied in a 400 kton/year hydroisomerization dewaxing plant at a total pressure of 15 MPa, a feed rate of 38 ton/hour, and a ga...

Vegetable oils and fats in comparison with diesel fuel have high viscosity, by transesterification method the viscosity of oil can be decreased. Transesterification of triglyceride with alcohol is one of the methods for production of biodiesel. In this study sunflower oil, methanol and ethanol, with molar ratio of (1:3, 1:4, 1:6, 1:8) and temperature (40, 50, 60 º C) were dependent parameters e...

This paper addresses the generation and control of oil droplets in rolling piston type refrigerant compressors at speeds greater than 5000 RPM. This work is part of the development of a variable speed compressor which addresses the problem of critically low oil sump levels that can occur at these extreme speeds. This paper identifies the dominant mechanism of oil droplet generation based on exp...

HFC-134a is used as working fluid in refrigerators widely. However, how to improve the efficiency of compressor and refrigerator is major topic in the word. The purpose of this study is aimed at the performance evaluation of compressors with different viscosity of POEs oil. A hermetic reciprocating compressor using HFC-134a as refrigerant was adopted and the experimental investigation was carri...

In the present work, the influences of temperature, solvent concentration and ultrasonic irradiation time were numerically analyzed on viscosity reduction of residue fuel oil (RFO). Ultrasonic irradiation was applied at power of 280 W and low frequency of 24 kHz. The main feature of this research is prediction and optimization of the kinematic viscosity data. The measured results of eighty-four...

PURPOSE To develop new blends of emulsification-resistant silicone oil based on high molecular weight (HMW) silicone oil for use as an endotamponade in vitreoretinal surgery. METHODS Viscosity and elasticity of various silicone oil blends (Siluron 1000, Siluron 2000, Siluron 5000, 7% HMW + Siluron 1000, 10% HMW + Siluron 1000, and 15% HMW + Siluron 1000; Fluoron GmbH, Ulm, Germany) were measu...

The objective of this work was to evaluate the influence of inlet air temperature and emulsion composition (total solid content and oil concentration), as well as its associated properties (viscosity and droplet size), on the microencapsulation of flaxseed oil by spray drying, using gum Arabic as wall material. Coarse emulsions were prepared by blending the flaxseed oil and the gum Arabic solut...

In many practical flow situations solutions of flexible polymers are found to exhibit a well-known non-Newtonian viscosity enhancement effect. This is likely to be due to extensional components in the flow field, which can cause flexible polymer molecules to stretch and orientate, causing an increase in the extensional viscosity. This viscosity enhancement is important in many industrial applic...

Vegetable oils are renewable in nature and can be directly used as fuels in diesel engines. However, their high viscosity and poor volatility lead to reduced thermal efficiency and increased hydrocarbon, carbon monoxide and smoke emissions. Transesterification is one of the methods by which viscosity could be drastically reduced and the fuel could be adopted for use in diesel engine. This Ester...