The three major distress conditions affecting the performance of asphalt pavements are permanent deformation or rutting, fatigue or load associated cracking, and low temperature or thermal cracking. In an earlier technical topics article (Fall, 1998), we examined the causes of fatigue cracking and the importance of good compaction during construction to help minimize this type of distress. In t...

The thermal cracking of hydrocarbons for olefin production is carried out in long tubular reactors inserted in a furnace, in this process the heat flux along the reactor wall determines the feedstock conversion, the olefin selectivity's and rate of coke deposition. A detailed firebox simulation model is therefore a powerful tool in the design and operation of pyrolysis furnaces and reactors to ...

Manuscript for the special IECR issue CREVIII conference held in Barga, Italy on June 24-29, 2001 Catalytic Cracking of Cumene in a Riser Simulator A catalyst activity decay model S.Al-Khattaf (2) and H. de Lasa (1.*) (1) Chemical Reactor Engineering Centre, Faculty of Engineering Science, University of Western Ontario, London, Ontario, Canada N6A 5B9 (2) Department of Chemical Engineering, Kin...

Ethylene is the primary component in most plastics, making it economically valuable. It is produced primarily by steam-cracking of hydrocarbons, but can alternatively be produced by the dehydration of ethanol, which can be produced from fermentation processes using renewable substrates such as glucose, starch and others. Due to rising oil prices, researchers now look at alternative reactions to...

lurestan province is petroliferous area. the reserved oil are in ilam and sarvak  (cretaceous ) and kangan ( lower triassic ) and dalan (permian) formations. the lurestan area had high exploration activity but contribution of source rocks in hydrocarbon accumulations isn’t clear. in this paper essential elements and process of hydrocarbon accumulation are introduced. candidate  source  rocks ar...

J. Kasińska, Faculty of Mechatronics and Machine Design, Kielce University of Technology, Kielce, Poland The article presents the analysis of fracture surfaces after the three-point bending test at a temperature range from + 20 °C to 80 °C. The author shows a beneficial effect of mischmetal on the cracking mechanism and on the character of fractures. It has been shown that the width of the duct...

This paper reports on direct thermal to electrical energy conversion by performing the Olsen cycle on pyroelectric materials. The energy harvesting capability of commercially available [001] oriented 68PbMg1/3Nb2/3O3–32PbTiO3 (PMN–32PT) single crystal capacitors was measured experimentally. An energy density of 100 mJ cm−3/cycle, corresponding to 4.92 mW cm−3, was obtained by successively dippi...

Thermodynamic analysis of the cracking of hexane has been conducted by the Gibbs free energy minimization method and second law analysis of overall reactions. By-products have been divided into three groups of methane, alkynes and aromatics and their possible production paths have been discussed. Effect of operating conditions such as temperature and steam-to-hexane ratio on the cracking perfor...

Pyrolysis of low density polyethylene (LDPE) by equilibrium fluid catalytic cracking (FCC) was studied in a stirred reactor under different process parameters. In this work, the effect of process parameters such as degradation temperature (420-510°C), catalyst/polymer ratio (0-60%), carrier gas type (H2, N2, ethylene, propylene, Ar and He), residence time and agitator speed (0-300 rpm) on the c...