graphene sheet including single vacancy, double vacancy and stone-wales with armchair and zigzag structure was simulated using molecular dynamics simulation. the effect of defects on shear’s modulus, shear strength and fracture  strain was investigated. results showed that these shear properties reduce when the degrees of all kinds of defects increase. the dangling bond in sv and dv defected gr...

We study the stationary and transient behaviors of a microemulsion phase subjected to a shear flow. The system is described by a diffusion-convective equation that generalizes the usual Cahn-Hilliard equation. Nonlinear terms are treated in a self-consistent approximation. Shear, first and second normal stresses are calculated as momenta of the structure factor. Shear thinning is observed in st...

We studied relaxation by hygroscopic expansion of the interfacial polymerization shear stress of bonded resin composites. In the experimental set-up, resin composite-cured-to-glass strips bent due to the polymerization shrinkage. The strips were stored wet or dry. The curvatures of the bent strips were recorded, by the scanning of the glass surfaces with a contact profilometer, periodically ove...

In plunging jet flows and at hydraulic jumps, large quantities of air are entrained at the intersection of the impinging flow and the receiving body of water. The air bubbles are entrained into a turbulent shear layer and strong interactions take place between the air bubble advection/diffusion process and the momentum shear region. New air-water flow experiments were conducted with two free sh...

Artificial monolayer black phosphorus, so-called phosphorene, has attracted global interest with its distinguished anisotropic, optoelectronic, and electronic properties. Here, we unraveled the shear-induced direct-to-indirect gap transition and anisotropy diminution in phosphorene based on first-principles calculations. Lattice dynamic analysis demonstrates that phosphorene can sustain up to 1...

tables of maximum bending moment, shear force and support rections for simple bridges with span lengths ranging from 2m to 250m are presented.loadings are selected according to the specification given by the highways and transportation ministry of iran. the procedure of using the tables is shown by means of an example.

The present study focusses on the damping force control of shear mode magnetorheological (MR) damper for seismic mitigations. Therefore, the semi-active MR damper which can control the vibration is analyzed both experimentally and numerically. Carbonyl iron is used as the magnetic particle and Castrol Magnetec oil as carrier fluid throughout the study. MR damper is designed and fabricated, and ...

BACKGROUND The lumbar spine may experience significant shear forces during occupational tasks due to the force of gravity acting on the upper body when bending the trunk forward, or when performing tasks involving pushing or pulling. Shear force limits of 1000 N and 500 N have been recommended by previous authors for maximum permissible limit and action limit, respectively. METHODS The presen...

OBJECTIVE The purpose of this study is to determine if crawling wave elastography, a novel sonoelastography technique, can be used to provide quantitative measurements of thyroid tissue shear velocity (a measure of tissue stiffness) and distinguish between benign and malignant thyroid nodules. STUDY DESIGN Diagnostic test assessment. SETTING Academic university. SUBJECTS AND METHODS Fresh...

OBJECTIVES To perform preliminary measurements of the shear modulus of the vocal fold cover layer during intrinsic laryngeal muscle contraction. STUDY DESIGN Shear modulus was measured in an in vivo canine larynx and an ex vivo human larynx. METHODS Shear stress was applied to the transverse axis of the vocal fold using a modified linear skin rheometer (LSR) via an attached suction probe. T...