To clarify the friction durability, both during and after the high-temperature heating of nanometer-thick diamond-like carbon (DLC) films, deposited using filtered cathodic vacuum arc (FCVA) and plasma chemical vapor deposition (P-CVD) methods, the dependence of the friction coefficient on the load and sliding cycles of the DLC films, were evaluated. Cluster-I consisted of a low friction area i...

We demonstrate measurement and control of nanoscale single-asperity friction by using cantilever probes featuring an in situ solid-state heater in contact with silicon oxide substrates. The heater temperature was varied between 25 and 790 °C. By using a low thermal conductivity sample, silicon oxide, we are able to vary tip temperatures over a broad range from 25 ± 2 to 255 ± 25 °C. In ambient ...

The Kramers problem in the energy-diffusion limited regime of very low friction is difficult to deal with analytically because of the repeated recrossings of the barrier that typically occur before an asymptotic rate constant is achieved. Thus, the transmission coefficient of particles over the potential barrier undergoes oscillatory behavior in time before settling into a steady state. Recentl...

The sliding interfaces found in the body— within the eyes, the digestive system, and the articulating joints, for example—are soft and permeable yet extremely robust, possessing low friction. The common elements among these systems are hydrophilic biopolymer networks that provide physical surfaces, elasticity, and fluid permeability. Stiff, impermeable probes are traditionally used to assess th...

This paper presents the experimental research into high mechanical efficiency at thrust bearings of low-side scroll compressors for air conditioners with the new refrigerant R407C and Polyolester (POE) lubricant. In order to examine the friction loss at the thrust bearing under a test condition which is close to the actual running condition of compressors, the authors developed a friction test ...

AIM Compare surface roughness of 'aesthetic' nickel-titanium (NiTi) archwires with their dynamic frictional properties. METHODS Archwires investigated were: four fully coated tooth coloured [Forestadent: Biocosmetic (FB) and Titanol Cosmetic (FT); TOC Tooth Tone (TT); and Hawley Russell Coated Superelastic NiTi (HRC)]; two partially coated tooth coloured [DB Euroline Microcoated (DB) and TP A...

The objective of the article is to evaluate the impact of the friction force mouse-pad in the contraction level of the forearm muscles M. extensor carpi ulnaris, M. extensor digitorum and M. extensor carpi radialis longus. A standard protocol of mouse movements was performed involving horizontal, vertical and diagonal mouse displacements drag-anddrop type. The operators were instructed to execu...

In this review, we discuss the current knowledge on the tribology of human skin and present an analysis of the available experimental results for skin friction coefficients. Starting with an overview on the factors influencing the friction behaviour of skin, we discuss the up-to-date existing experimental data and compare the results for different anatomical skin areas and friction measurement ...