Structural transformations between disordered phases, such as liquid-liquid and amorphousamorphous transformations (polyamorphic transformations), have been a focus of interest for the past years. In water, amorphous-amorphous transformation was experimentally observed and transformation between two distinct liquid forms has also been examined [1]. Since a typical atomic configuration of silico...

High resolution synchrotron X–ray diffraction has been used to conduct in situ studies of the temporal evolution of phases during the isothermal growth of bainite. Two populations of austenitic material were identified: one corresponding to the initial austenite, the other to the carbon–enriched austenite associated with the bainitic ferrite. The observed lattice parameters and the asymmetry of...

The kinetics of martensitic transformation in austenitic Fe-Ni-Mo alloys depends on the carbon content. Analysis of carbon redistribution between f.c.c. solid solution and dislocation has been carried out with the help of internal friction (amplitude and temperature effects) study and stress relaxation tests. The martensitic transformation was proved by magnetic induction and thermal differenti...

the pseudo-elastic behavior of shape memory alloy (sma) truss and cantilever beam are investigated. brinson’s one-dimensional material model, which uses the twinned and detwinned martensite fractions separately as internal variables, is applied in the algorithm to establish the sma stress-strain characteristics. this material model also incorporates different young’s modulus for austenitic and ...

The inherent nonlinearities in the kinetics and heat transfer models of biomass pyrolysis have led to the applications of various numerical methods in solving the nonlinear problems. However, in order to have physical insights into the phenomena and to show the direct relationships between the parameters of the models, analytical solutions are required. In this work, approximate analytical solu...

The Al2O3–CaO–SiO2 ternary is a basic oxide system relevant for the Pedersen alumina production process and aluminothermic silicon with low environmental impact using secondary aluminium silica raw materials. Rheological property one of most important properties above applications. A phenomenological viscosity model, inspired by Calphad technique, has been proposed description rheological cover...

Abstract. Ultrafine-grained S322750 superduplex stainless steel has been obtained through high-pressure torsion (HPT) process. Microstructural evolution after the severe plastic deformation (SPD) shown no phase transformation. Isothermal heat treatment was applied process in order to promote secondary precipitation. Precipitation enhanced ultrafine-grained comparison coarse-grained at same isot...

In industry, the cost of production is an important factor and it is preferred to use conventional and low cost procedures for producing the parts. Heat treatment cycles and alloying additions are the key factors affecting the microstructure and mechanical properties of the cast steels. In this study an attempt was made to evaluate the influence of minor Mo addition on the microstructure and me...

A kinetic study of the transformation of HGdP2O7.1.5H2O into HGdP2O7.0.5H2O has been achieved by means of isothermal thermogravimetry experiments under controlled water vapour pressure. This pressure was found to have an accelerating effect upon the rate of reaction. The kinetic curves giving the extent of reaction versus time can be described using a Mampel's model. Via this modeling, values o...