This report summarizes work to examine interstage heating and cooling options for multiple reheat helium Brayton cycle power conversion system (PCS) designs. Previous work has demonstrated that thermal powers in the range of 2400 MWt can be readily derived from combining multiple single-expansion units derived from the 600-MWt, vertical shaft gas-turbine module helium reactor (GT-MHR). This PCS...

An in vitro preparation of the guinea-pig cornea was used to study the effects of changing temperature on nerve terminal impulses recorded extracellularly from cold-sensitive receptors. At a stable holding temperature (31-32.5 degrees C), cold receptors had an ongoing periodic discharge of nerve terminal impulses. This activity decreased or ceased with heating and increased with cooling. Reduci...

Existing building energy simulation tools have a purported tendency to over-predict heating use and, in some cases, to under-predict cooling use, an outcome often attributed to inappropriate assumptions about thermostat management. As a result, a systematic review was conducted for the purposes of determining typical heating and cooling set points for single-family houses in North America. The ...

A wind tunnel conditions the air flow for testing equipment, such as heat exchangers, over a wide range of conditions. In this paper, a procedure to develop the operating envelope for the tested equipment in a wind tunnel is presented. The temperature and humidity of the air that requires conditioning is controlled and maintained by the combination of cooling coil (or evaporator), heating eleme...

STATEMENT OF PROBLEM Porcelain fused to zirconia prostheses are widely used. However, porcelain chipping, spalling, fracture, and delamination are common clinical problems. Residual stresses of thermal origin have received attention, but clear data and firing guidelines remain absent. PURPOSE The purpose of this study was to measure the influence of heating and cooling protocols on the streng...

since the energy consumption has become one of the crisis of modern buildings, modeling the iranian past architecture patterns could be helpful. the shopping streets as one of the main sectors consuming energy locate near the open spaces it seems, therefore, they need more thermal comfort. however, using passive techniques, the iranian traditional bazaars architecture solved the problems regard...

There are (at least) two unsolved problems concerning the current state of the thermal gas in clusters of galaxies. The first is identifying the source of the heating which offsets cooling in the centers of clusters with short cooling times (the “cooling flow” problem). The second is understanding the mechanism which boosts the entropy in cluster and group gas. Since both of these problems invo...

Increasing attention has been given to energy utilization in Turkey. In this report, we present an energy efficiency evaluation and economic feasibility analysis of a geothermal heating and cooling system (GSHP) and a mechanical compression water chiller system (ACHP) to improve the energy utilization efficiency and reduce the primary energy demand for industrial use. Analyses of a mechanical w...

In this study a new desalination unit is established. It has four cells such as cooling cell, heating cell, evaporation cell and condensation cell. Seawater is pumped into cooling cell to be preheated and then goes to evaporation cell. In the new desalination unit the evaporation and condensation cell is heated and cooled by the heating and cooling cells respectively. The heating of the evapora...