In present paper, a numerical analysis for a rectangular cavity filled with a anisotropic porous media has been studied. It is assumed that the horizontal walls are adiabatic and impermeable, while the side walls of the cavity are maintained at constant temperatures and concentrations. The buoyancy force that induced the fluid motion are assumed to be cooperative. In the two extreme cases o...

thermal resistance of the external walls of buildings is highly important for reducing and optimizing the energy consumption needed for heating and cooling the buildings. identifying and evaluation of the thermal performance of common external wall systems can be very effective in improving the heat resistance. the hollow clay- block system extremely are in use in the iran construction system, ...

in this numerical study the the heat transfer and laminar nanofluid flow in the three-dimensional microchannels with triangular cross-section is simulated. for increase the heat transfer from the walls of the channel, semiattached & offset mid- truncated rib,s placed in the canal, and the tooth geometry and the impact is studied. in this study, the water is base fluid, and the influence of the ...

In this paper, we have tried to find a solution for quick transfer of nuclear wastes from pools of cool water to dry stores to reduce the environmental concerns and financial cost of burying atomic waste. Therefore, the rate of heat transfer from atomic waste materials to the outer surface of the container should be increased. This can be achieved by covering the bottom of the pool space with c...

introduction: frying phenomena occur during the immersion of the product in oil at a temperature of 150–200 ºc, where a simultaneous heat and mass transfer take place. this is the most popular thermal processes of potato cooking. this fast drying is critical to improve the mechanical and structural properties of the final product. these conditions lead to high heat transfer rates, rapid cooking...

In this work, analysis of heat transfer in porous fin with temperature-dependent thermal conductivity and internal heat generation is carried out using Chebychev spectral collocation method. The numerical solutions are used to investigate the influence of various parameters on the thermal performance of the porous fin. The results show that increase in convective parameter, porosity parameter, ...

Using of nanofluids and ducts with corrugated walls are both supposed to enhance heat transfer, by increasing the heat transfer fluid conductivity and the heat transfer area respectively. Use of a diverging duct with a jet at inlet section may further increase heat transfer by creating recirculation zones inside the duct. In this work two-dimensional incompressible laminar flow of a nanofluid e...

cooling towers are widely used in most industrial units to reject waste heat to the atmosphere. this paper deals with an experimental analysis of heat and mass transfer phenomena between water and air by direct contact in a cooling tower. the tower is filled with 6 type packing. in this study temperature and pressure drop and tower characteristics was used in determining experimentally the ther...