The use of simple plasma treatments and polymer deposition to tailor the anisotropic wetting properties of one-dimensional (1D) submicrometer-scale grooved surfaces, fabricated using interferometric lithography in photoresist polymer films, is reported. Strongly anisotropic wetting phenomena are observed for as-prepared 1D grooved surfaces for both positive and negative photoresists. Low-pressu...

Bridged ZnO nanorod arrays on a V-grooved Si(100) substrate were used as the photoanode of a photoelectrochemical (PEC) cell for water splitting. Photolithography followed by reactive ion etching was employed to create a V-grooved structure on a Si substrate. ZnO nanorod arrays were grown via a hydrothermal method. The light trapping and PEC properties are greatly enhanced using the bridged ZnO...

To obtain a higher heat transfer in the low Reynolds number flows, wavy channels are often employed in myriad engineering applications. In this study, the geometry of grooves shapes is parameterized by means of four angles. By changing these parameters new geometries are generated and numerical simulations are carried out for internal fully developed flow and heat transfer. Results are compared...

Using four experiments, this study investigates what amount of delay brings about maximal impairment under delayed visual feedback and whether a critical interval, such as that in audition, also exists in vision. The first experiment measured the Grooved Pegboard test performance as a function of visual feedback delays from 120 to 2120 ms in 16 steps. Performance sharply decreased until about 4...

This paper is focused on the design, fabrication and characterization of the conventional and tunable photonic devices based on grooved silicon, serving as one-dimensional (1D) photonic crystal. The advantages of these photonic structures are as follows: the large refractive index contrast, in-plane moulding of the light flow, the possibility to fabricate a composite photonic structures by fill...

In this work, we perform numerical simulation of fluid mixing in a floor-grooved micro-channel with wavy sidewalls which may impose perturbation on the helical flow induced by the slanted grooves on the channel floor. The perturbation is caused by separation vortices in the recesses of the wavy-walled channel as the Reynolds number is large enough. The results show that the effects of the wavy ...

Fast remaining thickness measurement using Lamb wave is presented for the purpose of maintenance of large structures like oil storage tanks and pipe networks. This study used a laser ultrasonic source to perform a high resolution remote scanning over aluminum plates with grooved and circular defects that were modeled on corrosions in plate-like structures. The antisymmetric A0 and symmetric S0 ...

The aim of this work was to develop an eddy current type pressure sensor and investigate its fundamental characteristics affected by the mechanical and electrical design parameters of sensor. The sensor has two key components, i.e., diaphragm and coil. On the condition that the outer diameter of sensor is 10 mm, two key parts should be designed so as to keep a good linearity and sensitivity. Ex...

An experimental and numerical investigation is performed into the power loss induced in grooved polymer optical fibers (POFs) subjected to combined bending and elongation deformations. The power loss is examined as a function of both the groove depth and the bend radius. An elastic-plastic three-dimensional finite element model is constructed to simulate the deformation in the grooved region of...