Fretting is a phenomenon that occurs at the contacts of surfaces that are subjected to oscillatory relative movement of small amplitudes. Depending on service conditions, fretting may significantly reduce the service life of a component due to fretting fatigue. In this regard, the analysis of stresses at contact is of great importance for predicting the lifetime of components. However, due to t...

It is recommended that one should not combine different metals in orthopaedic devices. The least noble metal in such a galvanic coupling is more likely to corrode. However, some studies have failed to show increased corrosion when titanium and stainless steel are combined. The aim of this study was to determine the fretting corrosion of the contact areas between screws and plates made of these ...

The use of metal-on-metal bearing surfaces for total hip arthroplasty increased dramatically in the past decade for a variety of reasons, including the advantage of using larger-diameter femoral heads to reduce instability. However, recent research suggesting negative outcomes and high failure rates associated with some of these implants has decreased their use. Further, the use of larger-diame...

The laser shock peening (LSP) process using a Q-switched pulsed laser beam for surface modification has been reviewed. The development of the LSP technique and its numerous advantages over the conventional shot peening (SP) such as better surface finish, higher depths of residual stress and uniform distribution of intensity were discussed. Similar comparison with ultrasonic impact peening (UIP)...

INTRODUCTION: In current total hip arthroplasty, modularity between the head-neck connection of the femoral stem is well established. More recently, implants with an additional modular connection between the neck and stem have become more popular. The ability to adjust the head centre relative to the stem axis intraoperatively, by connecting the neck in different positions, guarantees high vers...

Ti alloys become very popular in various engineering fields due to its light weight, high strength and good corrosion resistance properties. Nevertheless, its application is limited in many areas like: tribology, high temperature oxidation and aggressive corrosion fields due to its poor surface properties. Therefore, the proper surface treatment is required to increase the usageof Ti alloys in ...

This paper describes a finite element based method for simulating the effects of material removal, associated with fretting wear, on fretting fatigue parameters in a spline coupling. An incremental wear simulation technique is implemented with a single tooth finite element model of the coupling for symmetric loading, assuming equal wear on all teeth, using a comparatively coarse mesh model, for...

The stem-cement interface experiences fretting wear in vivo due to low-amplitude oscillatory micromotion under physiological loading, as a consequence it is considered to play an important part in the overall wear of cemented total hip replacement. Despite its potential significance, in-vitro simulation to reproduce fretting wear has seldom been attempted and even then with only limited success...

Fretting is a significant cause for the failure of orthopedic implants. Currently, since magnesium and its alloys have been developed as promising biodegradable implant materials, the fretting behavior of the Mg alloys is of great research significance. In this study, a Mg-Nd-Zn-Zr alloy (hereafter, denoted as JDBM alloy) was selected as experimental material, and its fretting behaviors were ev...

The Ti/TiN multi-layer film was prepared on the depleted uranium (DU) substrate by cathodic arc ion plating equipment. The character of multi-layer film was studied by SEM, XRD and AES, revealed that the surface was composed of small compact particle and the cross-section had a multi-layer structure. The fretting wear performance under different frequencies was performed by a MFT-6000 machine w...