Dip-coated films, which are widely used in the coating industry, are usually measured by capacitive methods with micrometric precision. For the first time to our knowledge, we have applied an interferometric determination of the evolution of thickness in real time to nonvolatile Newtonian mineral oils with several viscosities and distinct dip withdrawing speeds. The evolution of film thickness ...

Real-time interferometric monitoring of the dip coating process is applied to the study of properties of flowing liquids. Nonvolatile Newtonian oils are considered, allowing validity of a simple model after the steady state is reached where film physical thickness depends on time as t(-1/2). Measurement of two distinct mineral oil standards, under several withdrawing speeds, resulted in kinemat...

A new chemical compound is developed at Petroleum University of Technology to enhance the recovery of the free imbibition process and simultaneously hinder asphaltene precipitation. The compound is tested on heavy oil samples from Marun oil field, Bangestan reservoir. The effects of the chemical compound on viscosity, hydrocarbon composition, and average molecular weight of the heavy oil are in...

Squeeze film dampers are widely used in aircraft engines, land-based gas turbines, and other rotating machines to improve system damping. They often have entrained air within the oil film, which is usually not taken into account in rotordynamics analysis due to lack of good formulations of the effects involved. The effects on the damping force calculation can be significant. This work presents ...

Heavy high viscosity oils, transformer oils, and very light low viscosity oils have been used in a Norwegian company in the impregnation, sheathing, and installation of paper insulated cables. The aim of the present study was to determine exposures to oils and other chemicals at these workplaces from 1920 to 1979. Oil mist was sampled on glass fibre or membrane filters and analysed by infrared ...

Methyl and ethyl esters were prepared from camelina [Camelina sativa (L.) Crantz] oil by homogenous base-catalyzed transesterification for evaluation as biodiesel fuels. Camelina oil contained high percentages of linolenic (32.6 wt.%), linoleic (19.6 wt.%), and oleic (18.6 wt.%) acids. Consequently, camelina oil methyl and ethyl esters (CSME and CSEE) exhibited poor oxidative stabilities and hi...

This study offers comprehensive details on the use of bio-fuel as a viable and alternative source of energy. The bio-fuel was prepared from vegetable oil, i.e., mustard oil and tested in a diesel engine in both pure form and as a diesel blend. The mustard oil blend proportions were 20%, 30%, 40% and 50% and named as bio-diesel blends B20, B30, B40 and B50. A fuel-testing laboratory determined t...

The most important factor affecting efficacy and drift of pesticide applications is the droplet spectrum. To measure pesticide drift, researchers utilize fluorescent tracers to rapidly quantify spray deposition. Although fluorescent tracers have been used for more than 50 years, no experiments have been performed on the effect they have on the properties of pesticide formulations (density and v...

A combination of electrical conductivity, dynamic viscosity, dynamic light scattering and small angle X-ray scattering methods was used to study the properties of the water + propylene glycol/mixed nonionic surfactants/ peppermint oil + ethanol U-type microemulsions which can be diluted with any amount of water. The surfactants were sucrose laurate and ethoxylated mono-di-glyceride. The mixing ...

Rheological characteristics of Al2O3, CuO and TiO2 nano particles were investigated in oil asthe base fluid at 1 and 2 wt.%. Constitutive relations for non-Newtonian fluid were discussedbased on the power-law model. Measured viscosities of each nanofluid were used to evaluatethe power-law and consistency index. Results indicated that the nanofluid viscosity decreasedby increasing the concentrat...