In the previous studies, the several halocarbons (HC) were tested as promoters for a Ti-based Ziegler-Natta (ZN) catalyst at different polymerization conditions. The Results showed that chloro cyclohexane has the best operation in catalyst activity, polymer particle size growth, hydrogen responsibility and wax reduction too. For the first time in this study, the effect of Al/Ti ratio on the opt...

A highly active and stable nano structured Pt/Mg1-xNixO catalysts was developed by a simple co-precipitation method. The obtained Pt/Mg1-xNixO catalyst exhibited cubic structure nanocatalyst with a size of 50-80 nm and realized CH4 and CO2 conversions as high as 98% at 900°C with excellent stability in the dry reforming of methane. The characterization of catalyst was performed using various ki...

A novel silica catalyst was synthesized by evaporation-induced self-assembly (EISA) method and tested for the catalytic selective hydrolysis of cellulose to glucose. This silica catalyst exhibited a higher catalytic activity than other oxides prepared by the same method, such as ZrO2, TiO2, and Al2O3. Using silica as a catalyst, cellulose was selectively hydrolyzed into glucose with a glucose y...

The oxidation of toluene in air was investigated using a dielectric barrier discharge (DBD) combined with a Pd/Al2O3 catalyst. When using only plasma, rather low selectivity toward CO2 was obtained: 32-35%. By filling the DBD reactor with Pd/Al2O3 catalyst the CO2 selectivity was significantly enhanced (80-90%), however, a large amount of toluene was desorbed from the catalyst when the discharg...

In general, Lewis acid catalysts are metal-based compounds that owe their reactivity to a low-lying empty orbital. However, one potential Lewis acid that has received negligible attention as a catalyst is the carbocation. We have demonstrated the potential of the carbocation as a highly powerful Lewis acid catalyst for organic reactions. The stable and easily available triphenylmethyl (trityl) ...

The oligonucleotide [5'-32P]pdT8d(-)dT., containing an apurinic/apyrimidinic (AP) site [d(-)], yields three radioactive products when incubated at alkaline pH: two of them, forming a doublet approximately at the level of pdT8dA when analysed by polyacrylamide-gel electrophoresis, are the result of the f-elimination reaction, whereas the third is pdT8p resulting from ,8-elimination. The incubati...

A series of Pd-supported metal oxides (Al2O3, Fe2O3 and CeO2) have been prepared by a single step solution combustion synthesis (SCS). Their catalytic performance was evaluated for selective hydrogenation of cinnamaldehyde (CAL) to hydrocinnamaldehyde (HCAL) under atmospheric pressure of hydrogen at 100 °C. Among these materials, combustion synthesized Pd (2 at.%)/Al2O3 catalyst exhibits the hi...

N-methylol compounds, such as dimethyloldihydroxyethyleneurea (DMDHEU), are the most commonly used durable press finishing agents for cotton fabrics by the industry. In this research, we have examined the effects of the catalyst systems used for DMDHEU on the mechanical strength of the crosslinked cotton fabric. The catalysts induce degradation of cellulose as indicated by the decrease in the t...

Natural gas may be used instead of hydrogen as fuel for the molten carbonate fuel cell (MCFC) by steam reforming the natural gas inside the MCFC, using a nickel catalyst (internal reforming). The severe conditions inside the MCFC, however, require that the catalyst has a very high stability. In order to find suitable types of nickel catalysts and to obtain more knowledge about the deactivation ...

The performance of a direct methanol alkaline anion-exchange membrane (Fumatech FAA3) fuel cell with Pt-free nitrogen-doped few-walled carbon nanotubes (N-FWCNT) as the cathode catalyst is compared with a commercial supported Pt catalyst. The ionomer content of the N-FWCNT cathode catalyst layer is therefore optimized and it is shown to be 40 wt% of FAA3. Scanning electron microscopy images of ...