This study compares the abilities of four low-cost materials: eucalyptus bark, maize leaves, grape bunch and banana peel to remove cadmium from synthetic aqueous solutions. Kinetic data and equilibrium sorption isotherms were measured in batch conditions. Kinetics of cadmium sorption was contact time, initial cadmium concentration and sorbent type dependent. The results also showed that the kin...

The potential use of Croatian natural zeolite clinoptilolite as alternative adsorbents for removal of enrofloxacin (ENRO) as model pollutant was studied in a batch system. The influence of contact time and initial ENRO concentration on the sorption process was investigated. The percentage removal of ENRO from aqueous phase decreased with an increase in initial concentration. The experimental da...

We present the results of a study of the kinetics of adsorption on aggregates of open carbon nanohorns using argon and CF₄ sorbates. We measured the equilibration times for each value of the sorbent loading along eight adsorption isotherms (four isotherms for each sorbate species). We found that: the equilibration times decrease as the sorbent loading (and the equilibrium pressure of the coexis...

Removal of heavy metals from wastewater is obligatory in order to avoid water pollution. In the present study, performance of Dowex HCR S/S cation exchange resin was evaluated for removal of nickel and zinc from aqueous solutions. Batch shaking adsorption experiments were performed in order to examine the effects of pH, dosage of resin and contact time on removal process. It was observed that m...

We present isotherms for the adsorption of n-butane on the external and internal surfaces of silicalite, in the temperature range of 320-400 K and at pressures up to 530 kPa. The isotherms were calculated using molecular dynamics simulations. A modified thermostatting algorithm, Soft-HEX, was developed for this purpose. The results for the external as well as the internal surface were fitted to...

Polycresol p (o-cresol) has been synthesized by cyclic voltammetry technique in acidic medium using sulfuric acid as an electrolyte at 30 o C. The electrosynthesized polymer was characterized by X-ray diffraction (XRD) and scanning electron microscope (SEM). The adsorption properties of the fabricated polymer were investigated for adsorptive removal of Pb (II) ions from aqueous solutions. Vario...

Carbon slurry, dried in open air, has been used as an adsorbent material for the removal of nickel(II) from aqueous solutions at different experimental conditions in batch adsorption technique. The time required to attain equilibrium was found to be 50 minutes. The effects of initial concentration of Ni(II), particle size of adsorbent, adsorbent dose, temperature and pH on removal of nickel(II)...

Batch adsorption of recalcitrant melanoidin using the abundantly available coal fly ash was carried out. It had low specific surface area (SBET) of 1.7287 m2/g and pore volume of 0.002245 cm3/g while qualitative evaluation of the predominant phases in it was done by XRD analysis. Colour removal efficiency was found to be dependent on various factors studied. Maximum colour removal was achieved ...

Separation of CO2 from CO2-CH4 mixtures is an important issue in natural gas and biogas purification. The design of such separation processes depends on the knowledge of the behavior of multicomponent adsorption, particularly that of CO2-CH4 mixtures. In this study, we present a series of experimental binary equilibrium isotherms for CO2-CH4 mixtures on an activated carbon at 293 K and compare ...

The surface properties of cholesteryl palmitate, stearate, linoleate, linolenate, arachidonate, and acetate were investigated. Long-chain esters were not surface-active and force-area (pi-A) isotherms were not obtained. Unsaturated cholesteryl esters were oxidized at the air-water interface and these oxidized lipids gave expanded pi-A isotherms. Cholesteryl acetate had an equilibrium spreading ...