AISI 301 stainless steel is a frequently used metal, especially in high temperature demands and or in part with high corrosion risk. Thin spring steel plates can be used as expansions of heat furnaces insulation and variety of all other springs. The present study has assessed the effects of temperature and thermal treatment time span on the microstructure of stainless steel 301 to achieve elast...

The local lattice strain evolution during electrochemical hydrogen charging and mechanical loading in 25Cr-7Ni super duplex stainless steel were measured in-situ using synchrotron high-energy x-ray diffraction. Post-mortem electron backscattered diffraction analysis showed that the austenite phase underwent plastic deformation near-surface due to hydrogen-enhanced localized plasticity, where fe...

Article history: Received 29.05.2012. Received in revised form 27.07.2012 Accepted 03.09.2012. The influence of sub-temperature quenching temperature on the tensile strength, hardness and toughness of 60Si2Mn steel has been studied, and the ferrite content, austenite grain size and martensite morphology of the microstructure of this steel after sub-temperature quenching analyzed. The results sh...

Cost reduction and high efficiency are the mayor challenges for sustainable H2 production via proton exchange membrane (PEM) electrolysis. Titanium-based components such as bipolar plates (BPP) have the largest contribution to the capital cost. This work proposes the use of stainless steel BPPs coated with Nb and Ti by magnetron sputtering physical vapor deposition (PVD) and vacuum plasma spray...

Iron chromium oxide microspheres were generated by pulsed laser irradiation on the surface of two commercial samples of stainless steel at room temperature. An Ytterbium pulsed fiber laser was used for this purpose. Raman spectroscopy was used for the characterization of the microspheres, whose size was found to be about 0.2-1.7 μm, as revealed by SEM analysis. The laser irradiation on the surf...

Radiation damage will be a major key point in the design of the many duplex components in fusion reactors. There is a substantial amount of available data showing that stress plays a major role in the onset, and possibly the rate, of void growth in austenitic stainless steels. There is also a strong support for models which predict a coupling of swelling and creep through the stress environment...