The aim of this study was to evaluate the effects of dentin surface treatments on the tensile bond strength (TBS) of the self-etching primer Clearfil SE Bond (CSE) and the one-step self-etching One-Up Bond F (OUB). The exposed flat dentin surfaces of twenty-four sound third molars were prepared with diamond bur at high-speed, carbide bur at low-speed or wet ground with #600 grit SiC paper. The ...

BACKGROUND This study aimed to assess the effect of surface preparation with sandblasting and diamond bur along with the use of three primers on shear bond strength (SBS) of metal brackets to aged composite. MATERIAL AND METHODS In this in vitro, experimental study, 60 Filtek Z250 composite discs were fabricated (10×2mm), immersed in distilled water for 24 hours and subjected to 5000 thermal ...

BACKGROUND Fibre reinforced composite bars (FRC) have applications as bonded retainers, space maintainers and anchorage/movement units. However, the bond strength of attachments to FRC anchorage bars is unknown. AIMS To compare the shear bond strengths of brackets bonded immediately to FRCs with different orthodontic adhesive systems and bonded with the same adhesives after a 48-hour delay, a...

introduction: the aim of this study was to evaluate the composite surface treated by different powers of erbium-doped yttrium aluminum garnet (er:yag) laser in comparison with bur preparation via scanning electron microscope. methods: fourteen composite resin blocks with 15× 10 × 10 mm dimensions were used in this study. the samples were divided to seven groups as follow: group 1 (power: 1 w, e...

The aim of this case report is to present a technique for removing the denture which locked to ball-attachment because of excessive hard relining resin material flows around the ball-attachment. An alternative method was used in the present case. A cylindrical resin was removed with a diamond bur at the level of matrix and by this way the matrix was removed safely. The advantage of the presente...

OBJECTIVES The purpose of this in vitro study was to evaluate whether mechanical alteration of the enamel surfaces with air abrasion and bur abrasion techniques could enhance the bonding performance of a three step and a self etching adhesive resin systems to enamel. METHODS 126 extracted lower human incisor teeth were used. The teeth were divided into three groups including 40 teeth each. Fi...

The purpose of this in vitro study was to evaluate the surface and resin-dentine interface characteristics of permanent tooth dentine cut with diamond or carbide burs and treated with phosphoric acid (PA) or an acidic conditioner. Labial surfaces of permanent incisors were prepared into dentine with high-speed carbide or diamond burs and divided into two halves. Phosphoric acid 36% was applied ...

OBJECTIVE The purpose of this study was to compare laser with conventional techniques in class V cavity preparation in gamma-irradiated teeth. METHODS Forty extracted human teeth with no carious lesions were used for this study and were divided into two main groups: Group I (n = 20) was not subjected to gamma radiation (control) and Group II (n=20) was subjected to gamma radiation of 60 Gray....

statement of the problem: porcelain laminate veneer is an esthetic restoration used as an alternative to full veneer crowns and requires minimal tooth preparation. in restoration with porcelain laminate veneers, both the longevity of the laminate and conservation of the sound tooth structure are imperative. purpose: the present study aimed to investigate the shear bond strength of porcelain lam...