The local time-dependent surface heat transfer coefficients for plate finned-tube heat exchangers are estimated in a three-dimensional inverse heat conduction problem. The inverse algorithm utilizing the Steepest Descent Method (SDM) and a general purpose commercial code CFX4.4 is applied successfully in this study in accordance with the simulated measured temperature distributions on the fin s...

Nanofluid is a new class of heat transfer fluids engineered by dispersing metallic or non-metallic nanoparticles with a typical size of less than 100 nm in the conventional heat transfer fluids.This article aims to investigate the overall and convection heat transfer coefficient and Nusselt number of Al2O3-water nanofluid flowing in a horizontal double pipe heat exchanger under turbulent flow (...

a thermodynamic analysis of the counter flow wet cooling tower (cwct) in the steelmaking unit of the khuzestan steel company (ksc) is performed in this paper. we evaluated both energy and exergy formulations for analyzing the heat and mass transfer, exergy and second-law efficiency in this cooling tower. the lewis factor le f is an indication of the relative rates of heat and mass transfer in a...

The in-flight ice formation and accretion are highly dependent on weather conditions that essentially affect the heat transfer capability. When the temperature is sufficiently cold, the heat transfer is adequate to remove all of the latent heat from the collected water. The rate of rime ice accretion is controlled by the droplet collection efficiency. Otherwise, when the heat transfer is inadeq...

an investigation on the thermal performance of the soil as geothermal heat energy storage medium has been conducted. the thermal characteristics of the soil storage and the heat transfer from a heat exchanger in the soil, surrounding and bottom surface will be discussed. this investigation forms a contribution to a project to realize such storage to be charged from a solar heating system. this ...

in this paper, wavelet collocation method has been used to solve nonlinear fin problem with temperature dependent thermal conductivity and heat transfer coefficient. thermal conductivity of fin materials varies any type so that we consider thermal conductivity as the general function of temperature.  here we consider three particular cases, where we assume that thermal conductivity is constant,...

The potential of nanofluids for the improvement of heat transfer coefficient in various heat exchangeequipment has been considered and studied as a major application during recent decades. In this research,heat transfer coefficient of ZnO, TiO2 and ZnO/TiO2 nanofluids in a shell and tube heat exchanger has beenstudied experimentally. ZnO nanoparticle was synthesized through pre...

The single-phase flow and thermal performance of a double pipe heat exchanger are examined by experimental methods. The working fluid is water at atmospheric pressure. Temperature measurements at the inlet and outlet of the two streams and also at an intermediate point half way between the inlet and outlet is made, using copper-constantan thermocouple wires. Mass flow rates for each stream are ...

This paper presents the heat transfer coefficients and the pressure drop measured during HC-600a (Isobutane) condensation inside a brazed plate heat exchanger: the effects of saturation temperature, refrigerant mass flux and vapour super-heating are investigated. The heat transfer coefficients show weak sensitivity to saturation temperature and great sensitivity to refrigerant mass flux. At low...

one way to increase the heat transfer is to use perforated twisted tapes with different hole diameters, which largely improve heat transfer with an increase in the heat transfer area at the constant volume and more mixed flow. in the previous studies, the effect of nanofluids with perforated twisted tapes is less studied. in this work, the performance of water / iron oxide nanofluid in a double...