The distinguishing characteristics of carbon fibre reinforced laminates, like low weight, high strength or stiffness, had resulted in an increase of their use during the last decades. Although parts are normally produced to “near-net” shape, machining operations like drilling are still needed. In result of composites non-homogeneity, this operation can lead to delamination, considered the most ...

This paper presents a prediction and evaluation of delamination factor in use of twist drill, candle stick drill and saw drill. The approach is based on Taguchi’s method and the analysis of variance (ANOVA). An ultrasonic C-Scan to examine the delamination of carbon fiber-reinforced plastic (CFRP) laminate is used in this paper. The experiments were conducted to study the delamination factor un...

The effects of temperature and loading rate on delamination growth were studied. The delamination fracture toughness of IM7/K3B was measured at 149°C, 177°C, and 204°C. At each temperature the tests were performed with a variety of loading rates so that the delamination initiated over the range of time from 0.5 sec to 24 hrs. The double cantilever beam (DCB) test was used to measure fracture to...

Delamination of premigratory neural crest cells depends on a balance between BMP/noggin and on successful G1/S transition. Here, we report that BMP regulates G1/S transition and consequent crest delamination through canonical Wnt signaling. Noggin overexpression inhibits G1/S transition and blocking G1/S abrogates BMP-induced delamination; moreover, transcription of Wnt1 is stimulated by BMP an...

Channeling cracks in low-k dielectrics have been observed to be a key reliability issue for advanced interconnects. The constraint effect of surrounding materials including stacked buffer layers has been studied. This paper analyzes the effect of interfacial delamination on the fracture condition of brittle thin films on elastic substrates. It is found that stable delamination along with the gr...

Drilling is the most frequently employed operation of secondary machining for fiber-reinforced materials owing to the need for structure joining. Delamination is one of the serious concerns during drilling. Practical experience shows that an eccentric twist drill or an eccentric candle stick drill can degrade the quality of the fiber reinforced material. Comprehensive delamination models for th...

in this work, homogeneous thermochemical co-precipitation method was used to fabricate w-25wt%cu nanocomposite. synthesized nanocomposite powder was calcined and reduced. a hydrogen atmosphere sintering at 1200oc for 105 consolidated the product up to a density close to 98% theoretical density. wear experiment were carried out using a pin-ondisc set up at three normal loads of 5, 10 and 15 n an...

Finite element analysis of the delamination crack propagation in laminated composites is presented. Fracture mechanics based Virtual Crack Closure Technique (VCCT), and the cohesive element technique, have been used to simulate the delamination initiation and propagation under Mode-I type loading. Detailed description of the parameter selection process for these two techniques with ABAQUS®/Stan...

Complex composite parts, and especially curved laminated composites, are more subject to defects than flat laminates. One of the most common is presence wrinkles, which can occur in radius curvature. Wrinkle effects must be studied evaluate their influence on mechanical properties composites. In this study, a numerical model was developed take wrinkle local delamination into consideration asses...