in this paper, seismic behavior of the existing buildings equipped by friction dampers is studied. seismic performance of6-story, 9-story and 12-story steel buildings with damper and without damper were studied. the finite element modeling technique (sap2000 software) is used for analysis. time history analyzing was done to achieve this purpose. for nonlinear dynamic analysis, the responses of ...

in this study, mass, stiffness and damping matrices of the nosrat jacket; located in persian gulf; equipped with semi active tuned mass damper (satmd) system have been derived after modeling the structure in sacs software. owing to huge number of the degrees of freedom in the model, computation of on-line control of satmd was time consuming. for this purpose, the size of the model was reduced i...

It is important to reduce the seismic response of houses in order to prevent from collapse of houses. Some control methods for seismic response of houses are developed. The oil dampers using the flow resistance of the silicon oil have been developed. In this paper, a Magnet Oil Damper (MOD) in which permanent magnets are added to the oil damper is proposed in order to improve the performance of...

The major concern in the construction industry in constructing tall structures is vibration due to wind and earthquake. Tuned mass dampers are an effective and practical ways to reduce the effect of vibration in structures. This thesis presents a tool, which simulates the effect of tuned mass dampers on the structure. This tool has been proposed to form a part of the website, moment.mit.edu. Ja...

Original scientific paper This paper considers using the Energy Balance Method for estimation of overhead transmission line Aeolian vibrations. Since the damper’s efficiency strongly depends on its position, the procedure of determining the optimum position of the damper is described. It is observed that the optimal damper position depends on the span length also and that the best results can b...

The objective of this paper is to study the performance of a sixth order polynomial approach to model hysteresis behaviour of a magnetorheological (MR) damper under harmonic excitations. The polynomial model is developed based on curve fitting from the experimental results and consists of a pair subsystem namely positive and negative acceleration which correspond to the upper and lower curves. ...

In this study, control performance of a smart base isolation system consisting of a friction pendulum system (FPS) and a magnetorheological (MR) damper has been investigated. A fuzzy logic controller (FLC) is used to modulate the MR damper so as to minimize structural acceleration while maintaining acceptable base displacement levels. To this end, a multi-objective optimization scheme is used t...

Repetitive Control is a relatively new technique for controlling systems that contain periodic reference signals or periodic disturbances. The fundamental idea behind the method is to use the internal model of the periodic signal to guarantee asymptotic reference tracking or disturbance rejection. In this paper two recent Repetitive Control algorithms are applied to a simulation model of a damp...

Estimation of the system parameters, given noisy input/output data, is a major field in control and signal processing. Many different estimation methods have been proposed in recent years. Among various methods, Extended Kalman Filtering (EKF) is very useful for estimating the parameters of a nonlinear and time-varying system. Moreover, it can remove the effects of noises to achieve significant...

A series of large-scale experimental tests is conducted on a mass equipped with a hybrid controlled base-isolation system that consists of rolling pendulum system (RPS) and a 20 kN magnetorheological (MR) damper. The 12-ton mass and its hybrid isolation system are subjected to various intensities of nearand far-fault earthquakes on a large shake table. Fuzzy controllers use feedback from displa...