Internal corrosion is a common problem in pipelines transporting oil and gas containing corrosive components such as CO2 and H2S. In many mature oil wells, the water cut and CO2 content may reach high level which forms a suitable environment for initiation and growth of corrosion. To avoid the consequences of corrosion, process parameters should always be controlled within safe operating limits...

The galvanic corrosion behavior of Alloy 690 coupled with magnetite has been investigated in an alkaline solution at 30 °C and 60 °C using a potentiodynamic polarization method and a zero resistance ammeter. The positive current values were recorded in the galvanic couple and the corrosion potential of Alloy 690 was relatively lower. These results indicate that Alloy 690 behaves as the anode of...

Linear Polarisation Resistance (LPR) can provide a direct evaluation of the instantaneous rate of corrosion. However it has the disadvantage of requiring a localised breakout of the concrete cover to provide an electrical connection to the steel reinforcement. This paper describes an adaptation of the LPR method and the four-point Wenner resistivity method to give an evaluation of the rate of s...

The corrosion behavior of pure Fe under a Na₂SO₄ deposit in an atmosphere of O₂ + H₂O was investigated at 500 °C by thermo gravimetric, and electrochemical measurements, viz. potentiodynamic polarization, electrochemical impedance spectroscopy (EIS), and surface characterization methods viz. X-ray diffraction (XRD), and scanning electron microscope (SEM)/energy dispersive spectroscopy(EDS). The...

The influence of potential on contact angle and the effect of TPB width on the cathodic corrosion processes of metals were studied by steady polarization and EIS technique combined with contact angle measurement. It is found that both cathodic limiting current density and corrosion current density linearly increases with increasing the TPB width, confirming the important role of TPB width in ga...

An improved model for nuclear fuel corrosion inside a failed waste container has been developed. The model considers the influence of the a-radiolysis products using a full radiolytic reaction set, and demonstrates that H2O2 is the dominant oxidant. Corrosion of the fuel is modelled considering both the direct oxidation of UO2 by H2O2 and the galvanically-coupled oxidation by H2O2 reduction on ...

vanillin is an interesting corrosion inhibitor because of its safe use and high solubility inwater. the effect of vanillin on the corrosion inhibition of carbon steel in 1.0 mhydrochloric acid solution has been studied using potentiodynamic polarization,electrochemical impedance spectroscopy (eis) and electrochemical noise (en) techniques.the effect of temperature on the rate of corrosion in th...

The carbon dioxide corrosion electrochemistry of mild steel has been studied in the presence of high CO2 partial pressures and acetic acid (HAc). Potentiodynamic sweeps, linear polarization resistance (LPR) and weight loss (WL) experiments have been conducted to investigate the effects of flow velocity, CO2 partial pressure, and acetic acid concentration on the corrosion rate of mild steel. Ele...

• Introduction • Steel Composition and Mechanical Properties • Welding of Steel • Microstructure of NUCu-OSM Steel • Estimate of Atmospheric Corrosion Resistance of NUCu-OSM Steel • Summary • Acknowledgment • References • Appendix 1. Monotonic Tensile Stress-Strain Curves for NUCu-OSM Steel • Appendix 2. Steel Compositions and Concentration Ranges in Data Bases Used for Atmospheric Corrosion Ra...

In principle, any method to determine the corrosion rate can be used to test a corrosion inhibitor. The primary criterion for evaluation is the inhibitor efficiency. Inhibitors having sufficiently high efficiency are tested for "side effects," which include environmental compatibility, emulsion formation, viscosity and pour point density. Finally, the inhibitor formulation is tested in the fiel...