The corrosion behavior of pure Ti under a solid NaCl deposit in a wet O2 flow at 600 ̋C has been studied. The results showed that the corrosion rate was greatly accelerated by solid NaCl, which destroyed the compact and protective TiO2 scale to yield non-protective N4Ti5O12 and other products. Detailed scanning electron microscopy (SEM) equipped with an energy dispersive spectrometer (EDX), and...

The effect of several Almen intensities of shot peening on the corrosion behavior, surface roughness, micro hardness profiles, and residual stresses of stainless steel AISI 316 L were investigated. Hydroxyapatite coating (HA) were applied to shot peened materials to improve their corrosion resistance. The corrosion behaviour were studied using potentiodynamic polarization. The electrochemical t...

In the present paper, the evolution of an oxidation process has been associated to the collective atomic arrangement, the microstructure one. This microstructural analysis encompasses a metallographic examination and a relation of electricity to chemical changes in salt-water solution. The electrochemical experimental techniques used include corrosion potential measurements. To seek a deeper un...

The corrosion behavior of the fusion zone of gas tungsten arc (GTA) welds of AA6061 alloy was studied. Role of gas tungsten arc welding techniques such as continuous current (CC) and pulsed current (PC) and reference filler (AA5356) were studied. Role of different grain refiners such as scandium, zirconium and Tibor in the reference filler was studied. Dynamic polarization testing was used to d...

The high-velocity oxygen-fuel (HVOF) spraying process was used to fabricate conventional WC-10Co-4Cr coatings and FeCrSiBMn amorphous/nanocrystalline coatings. The synergistic effect of cavitation erosion and corrosion of both coatings was investigated. The results showed that the WC-10Co-4Cr coating had better cavitation erosion-corrosion resistance than the FeCrSiBMn coating in 3.5 wt.% NaCl ...

Corrosion behavior of solution annealed high-carbon and low-carbon CoCrMo wrought alloy, commonly used in medical joint implants, was investigated. The surface passivation properties remained similar with and without the various solution anneal conditions, while the rate of corrosion was lower for solution annealed high-carbon CoCrMo. Corrosion was found to target phase boundaries and certain g...

Polarized neutron reflectometry has been used to investigate the detailed adsorption behavior and corrosion inhibition mechanism of two surfactants on a nickel surface under acidic conditions. Both the corrosion of the nickel surface and the structure of the adsorbed surfactant layer could be monitored in situ by the use of different solvent contrasts. Layer thicknesses and roughnesses were eva...

this work is aimed to evaluate the role of nanoclay in the protective performance of an eco-friendly silane sol-gel layer applied on mild steel substrate in 0.1m sodium chloride solution. at the first step, the effect of ph of the silane solution, consisting of a mixture of γ-glycidoxypropiltrimethoxysilane and methyltriethoxysilane and tetraethoxysilane, on the coating performance was evaluate...

Fe-2.25Cr-1Mo a widely used material for headers and steam tubes of boilers. Welding of steam tube to header is required for production of boiler. Heat affected zone of the weld can have poor mechanical properties and poor corrosion behavior leading to weld failure. The cost of material used for steam tube and header of boiler should be controlled. This study propose a new materials design for ...

The in vitro corrosion mechanism of the biodegradable cast Mg-10% Ca binary alloy in Hanks' solution was evaluated through transmission electron microscopy observations. The corrosion behavior depends strongly on the microstructural peculiarity of Mg₂Ca phase surrounding the island-like primary Mg phase and the fast corrosion induced by the interdiffusion of O and Ca via the Mg₂Ca phase of lame...