The fly back converter has been widely used for multi outputs due to the simple structure and low cost in low-power applications. This paper presents a new multi output converter. It consists of a half-bridge inverter with boost converter in primary side and a fly back rectifier that is integrated with an auxiliary buck converter in secondary side. The boost converter is used to generate high v...

The paper analyzes the influence of material from which ferromagnetic core a transformer is made on characteristics full-bridge converter. Experimental investigations were carried out for three bridge converters containing transformers with ring cores various materials: iron powder, ferrite, and nanocrystalline material. properties aforementioned considered in wide range changes input voltage, ...

In this paper, a new structure for buck-boost Z-source converter based on Z-H topology is proposed. The proposed converter consists of two LC networks similar to the conventional Z-source and Z-H converters. One of the characteristics of the proposed structure is that, without any changing in its’ power circuit, it can be used in different conversions such as dc/dc, dc/ac and ac/ac. This unique...

− In this paper, small signal characteristic of a LLC resonant converter is analyzed. LLC resonant converter was been reported in many papers recently because of its simple structure, high efficiency and high switching frequency capability. In order to make practical use of this topology, understanding its small signal characteristic is essential to design the control loop. For PWM converter, s...

With the development of power electronics devices, resonant converter is proved to be more efficient than conventional converter as it employs soft switching technique. Among the three basic configuration of resonant converter, Series Resonant Converter (SRC), Parallel Resonant Converter (PRC) and Series Parallel Resonant Converter (SPRC), the LLC configuration under SPRC is proved to be most e...

In the current study, reduction of nitrogen oxide from exhaust gas in the presence of NH3 as reductant on selective catalytic reductant (SCR) impregnated catalytic converter was simulated using Comsol© software. Mass transfer (one-dimensional) and heat transfer (three-dimensional) governing equations were taken into account to model the unsteady state behavior of the catalytic converter. Modeli...

In this paper fractional order averaged model for DC/DC Buck converter in continues condition mode (CCM) operation is established. DC/DC Buck converter is one of the main components in the wind turbine system which is used in this research. Due to some practical restriction there weren’t exist input voltage and duty cycle of converter therefor whole of the wind system was simulated in Matlab/Si...

The Nottingham ePrints service makes this work by researchers of the University of Nottingham available open access under the following conditions. · To the extent reasonable and practicable the material made available in Nottingham ePrints has been checked for eligibility before being made available. · Copies of full items can be used for personal research or study, educational, or not-for-pro...

This paper proposes a new passive snubber for enhancing the power conversion efficiency on a single phase ac-dc power factor correction (PFC) converter based on boost topology for battery charging systems. Soft switching can be achieved in the proposed converter with the proposed auxillary passive snubber circuit which is added to the conventional boost PFC converter. The converter switch is pr...

This paper presents novel concept of a multiple converter. It works in three modesAC-AC converter voltage regulator, AC-AC converter frequency changer and AC-DC converter. All three modes work simultaneously. AC-AC converter mode of operation alters low input frequency to high output frequency across the load. AC-DC converter mode of operates with variable amplitude across load. This concept is...