Estimating methane (CH4) emission rates using quantitative CH4 retrievals from the Next Generation Airborne Visible/Infrared Imaging Spectrometer (AVIRIS-NG) requires use of wind speeds. Model speeds have limited temporal and spatial resolution, meteorological station data are variable quality often not available near observed plumes, ultrasonic anemometers co-located with sources is impractica...

Foot-and-mouth disease is a highly contagious disease of cloven-hoofed animals, the control and eradication of which is of significant worldwide socio-economic importance. The virus may spread by direct contact between animals or via fomites as well as through airborne transmission, with the latter being the most difficult to control. Here, we consider the risk of infection to flocks or herds f...

This study evaluates source attribution of ozone (O3) in the southeast United States (US) within O3 lamina observed by the University of Alabama in Huntsville (UAH) Tropospheric Ozone Lidar Network (TOLNet) system during June 2013. This research applies surface-level and airborne in situ data and chemical transport model simulations (GEOS-Chem) in order to quantify the impact of North American ...

A new approach to the monitoring of granulation processes using passive acoustics together with precise control over the granulation process has highlighted the importance of particle-particle and particle-bowl collisions in acoustic emission. The results have shown that repeatable acoustic results could be obtained but only when a spray nozzle water addition system was used. Acoustic emissions...

Since the investigation of wear particles in rail transport started in late-1910s, the high mass concentration of these particles has raised worries among researchers concerned with air quality. However, effective action has yet to be taken because of lack of relevant knowledge. This thesis provides applicable information for the airborne wear particles in rail transport. Some aspects of their ...

air pollutants from iron and steel making operations have historically been an environmental concern. the factory located at ahwaz, iran, has two production lines namely, 630 and 650, which produce iron parallel edge. the objective of the study is to determine indoor respiratory particulate matter (rpm) and feo concentrations and their comparison with niosh standards. this is a cross–sectiona...

soil samples were collected from seven sites in and around the metropolitan area of mexicocity. the locations were chosen as possible sources of fugitive dusts which contribute to suspended particulate matter in the atmosphere of mexico city. x-ray fluorescence (xrf) was used to determine the concentrations of several major elements (si, k, ca, ti, mn, and fe), as well as of other trace element...

Each day people are exposed to millions of bioaerosols, including whole microorganisms, which can have both beneficial and detrimental effects. The next chapter in understanding the airborne microbiome of the built environment is characterizing the various sources of airborne microorganisms and the relative contribution of each. We have identified the following eight major categories of sources...