This study is a follow-up of previous work by the authors on the effects of processing variables on the deformation and fracture of 2024-T4 aluminum. In the previous work, four variables were incorporated into a Design of Experiments methodology: solution temperature, solution time, cooling rate and natural aging time. Solution time and cooling rate were found to be the most significant factors...

Bias temperature instability (among other problems) is a key reliability issue with nanoscale CMOS transistors. Especially in sensitive circuits such as sense amplifiers of SRAM arrays, transistor aging may significantly increase the probability of failure. By analyzing the Current Based Sense Amplifier circuit and Voltage-Latched Sense Amplifier circuit through HSPICE simulations, we observe t...

Several samples of mesoporous silica were prepared via sol-gel chemistry in the presence of CTAB as template with variation of stirring intensity and aging time, ratios of CTAB/SiO2 and NH4OH/H2O in synthesis mixture. Effects of aging temperature, hydrothermal treatment and ter-Butanol addition to the synthesis mixture on the textural properties of obtained samples were also studied. Results of...

-In this study bulk and thin cast samples were produced with an identical Sn3.9Ag0.6Cu composition. The thin cast material exhibited a much finer as-quenched microstructure than the bulk material with the IMC phase restricted to a thin network. Both the bulk and thin cast materials continually softened during room temperature aging, while both materials initially softened and then subsequently ...

A  facile  effective  stirring  aging  at  room  temperature  prior  to  conventional  hydrothermal treatment was employed in the template-free synthesis of micro- and nano-crystalline sodalites with  two  different  initial  gel  compositions.  The  effect  of  initial  Si/Al  molar  ratio,  NaOH concentration and stirring aging time were investigated on the morphology and particle size of the...

This paper describes the aging behavior of the oil impregnated repulped cellulose and compares it with the aging behavior of the oil impregnated standard cellulose. In order to evaluate the reliability of using repulped cellulose in transformers, the accelerated aging process was applied to both types of cellulose by increasing the temperature to 150 °C and their aging behavior was studied and ...

All organisms age, the rate of which can be measured by demographic analysis of mortality rates. The rate of ageing is thermally sensitive in ectothermic invertebrates and we examined the effects of temperature on both demographic rates of ageing and on cellular senescence in the blowfly, Calliphora stygia. The short lifespan of these flies is advantageous for demographic measurements while the...

The effect of aging temperature on discharge characteristics of the MgO film of alternating currentplasma display panels (AC-PDPs) has been investigated from the point of view of surface contamination on the MgO protective layer. AC-PDP front panel samples were tested with Ne-Xe (4%) gas discharge after aging at elevated substrate temperatures. Real time analysis of the plasma composition near ...

1 ABSTRACT ____ An experimental study was undertaken to establish the viscoelastic behavior of IM7/K3B composite in compression at elevated temperature. Creep compliance, strain recovery and the effects of physical aging on the time dependent response was measured for uniaxial loading at several isothermal conditions below the glass transition temperature (T g). The IM7/K3B composite is a graph...