In the manufacture of printed circuit boards, the copper dissolved during etching can be used to replace the copper needed for plating using a liquid ion-exchange agent. Extraction and stripping studies demonstrated the feasibility. The quality of the etchant was not affected by the presence of the ion-exchange agent. Good-quality deposits were plated from the stripping solution with a current ...

We created a coke-repellent inner surface in stainless steel (SS-321) tube using an enhanced chemical etching tactic. A water-borne solution was formulated by combining ion sequestering ligand (L), hydrogen peroxide (H), hydrochloric acid (C), and stabilizing agent (E or N). Three etchants, LHC, LHC-E, LHC-N, were therefore formulated, respectively. The metal surfaces achieved these etchants al...

We demonstrated a 51 cm long waveguide array on a poly(methyl methacrylate) sheet fabricated by silicon hard-molding technology. To reduce the silicon sidewall roughness, a wet-oxidation followed by a buffered oxidation etchant etching process is adopted, achieving a surface roughness of 1.2 nm. The waveguide obtained a total insertion loss of -15.1 dB and an adjacent channel cross talk below -...

Silicon nanostructure surface fabricated from metal-assisted etching have been demonstrated as high sensitivity matrix-free laser desorption/ionization mass spectrometry chip. The silicon nanostructure morphology was found to have direct effect to the mass spectrometry ionization efficiency. Creation of different silicon nanostructure morphologies by changing the metal thickness, etching time a...

The water content of phosphoric acid in etching silicon nitride and silicon dioxide plays an important role. An increase in water content increases the etch rate of silicon nitride and decreases the etch rate of silicon dioxide. The highest possible temperature for a fixed water content at atmospheric pressure in the system H2O-P2O5 is realized by boiling the liquid and refluxing the vapor phas...

We successfully achieve the tip-enhanced nano Raman scattering images of a tungsten disulfide monolayer with optimizing a fabrication method of gold nanotip by controlling the concentration of etchant in an electrochemical etching process. By applying a square-wave voltage supplied from an arbitrary waveform generator to a gold wire, which is immersed in a hydrochloric acid solution diluted wit...

Color metallography is a useful method for characterizing microstructures of steels with multiple phases. In this paper, application of three different color etching techniques for a bainitic-martensitic steel is reported. Comparisons between the results showed that 10% Na2S2O5 aqueous solution was the best etchant for distinguishing martensite, bainite and ferr...

OBJECTIVES This in vitro study evaluated the shear bond strength (SBS) of resin composite to feldspathic porcelain after acidulated phosphate fluoride (APF) gel treatment over different periods of time. METHODS One hundred and fifty-six feldspathic specimens were divided into 12 groups. Group C received no treatment (control group). Groups APF1 through APF10, ten experimental groups, were tre...

We have developed a new procedure for fabricating fused-silica emitters for electrospray ionization-mass spectrometry (ESI-MS) in which the end of a bare fused-silica capillary is immersed into aqueous hydrofluoric acid, and water is pumped through the capillary to prevent etching of the interior. Surface tension causes the etchant to climb the capillary exterior, and the etch rate in the resul...