Chip formation during dry turning of Ti6Al4V alloy has been examined in association with dynamic cutting force measurements under different cutting speeds, feed rates and depths of cut. Both continuous and segmented chip formation processes were observed in one cut under conditions of low cutting speed and large feed rate. The slipping angle in the segmented chip was 551, which was higher than ...

The influences of storage temperature and modified O2 and CO2 concentrations in the atmosphere on the post-cutting life and quality of fresh-cut pineapple (Ananas comosus) were studied. Temperature was the main factor affecting post-cutting life, which ranged from 4 days at 10 ◦C to over 14 days at 2.2 and 0 ◦C. The end of post-cutting life was signaled by a sharp increase in CO2 production fol...

this study was conducted in perennial alfalfa farm infected by weeds located at km 7 hamadan-tehran road in the spring of 2014 and 2015 in a randomized complete block design with 11 treatments and 4 replications compared with control to investigate the effects of different harvest times of first cutting on the increase or decrease in percentage of dry weight of weeds and also alfalfa in second ...

Studies were made on the duration of the prehatch period of Boophilus decoloratus and on the subsequent survival and viability of larvae under natural conditions. The length of the prehatch and larval survival periods was found to be inversely dependent on increased temperature. A high initial temperature at the time of female drop decreased the prehatch period further, resulting in synchronous...

the aim of this study was to determine the optimal cutting cycle in an uneven-aged beech forest in the north of iran. first of all, a logistic growth model was determined for an uneven aged forest. then, the stumpage price was predicted via an autoregressive model. the average stumpage price of beech was derived from actual timber, round wood, fire and pulpwood prices at road side minus the var...

Temperature control during the cutting process with different parameters such as cutting velocity and applying water cooling is essential to decrease the cutting force, increase the life of the cutting tool and decrease the machined surface temperature of work-piece. In this research, the temperature of machined surface and the chip-tool interface in orthogonal cutting process of Ti-6Al-4V were...