We have deposited a series of WC–Co coatings by the high velocity oxy fuel (HVOF) process, using three different powders, and different spray conditions. The powders are a nanocrystalline (Nanocarb), a near-nanostructured powder (Infralloy) containing a proprietary additive aimed at retarding grain growth, and multimodal (mixed micro and nano) powder (Nanomyte). HVOF spray conditions were stoic...

This study evaluated the surface hardness and wear resistance of indirect composites (Artglass and Solidex) and the existence of a correlation between these properties. Twenty-four specimens (12 per material) were fabricated using a polytetrafluoroethylene matrix (5.0 mm in diameter; 7.0 mm high) following an incremental technique. Polymerization was done with a xenon stroboscopic light curing ...

PURPOSE Severe wear of cast commercial pure (CP) titanium teeth was observed in a clinical survey. This study evaluated the wear resistance of cast CP titanium and titanium alloy teeth after the surface was modified using laser technology. METHODS Teeth patterns were duplicated from artificial first molars (Livdent FB30, GC, Japan). All teeth specimens were cast with CP Ti grade 3 (T-Alloy H,...

In this study, the effect of chromium carbide (Cr7C3) on abrasive wear behavior of Fe-C-Mo-FeCr composite was investigated. Composite, which was produced by a powder metallurgy route was containing 3 wt.% Mo, 1.5 wt. % C and 4,8,12 wt. % FeCr with the different particle sizes. In the experiments, wear resistance of samples were determined using different loads by a pin on disc wear tester. Micr...

Hypereutectic aluminum silicon alloys are mainly used in cast form in important components like pistons, cylinder liners, rocker arms, air conditioner compressors, brake drums, engine blocks, etc. These have inherent advantages of being high wear resistance, high strength to weight ratio, high corrosion resistance, good cast performance, high thermal conductivity, good weldability, etc. The inf...

The hardness and elastic modulus of several Zr, Pd, Cu, and La-based amorphous alloys were investigated using nanoindentation. Abrasive wear of these alloys was also evaluated and compared using nanoscratch techniques under a ramping load. Damage caused by scratching was examined using SEM. Material pile-up took place in all scratched samples, but to different degrees. The scratched surface was...

Despite the merits of glass ionomer cements (GICs), they suffer from weak mechanical properties such as low wear resistance. In this study, the mechanical properties of GICs after incorporating chitosan and nano-hydroxyapatite was investigated. The samples were prepared in four groups, including non-modified GIGs (NMGIC, n = 5), chitosan incorporated GICs (CHGIC, n = 5), nano-hydroxyapatite inc...

The purpose of this research paper is to study the tool wear and surface roughness of AISI 8620 material using coated ceramic tool by turning process. Ceramic cutting tools have outstanding material hardness, resistance to high temperatures, wear resistance, chemical stability and hot hardness. Ceramic tool with Al2O3 + TiC (golden) coating was used to investigate the surface roughness and tool...