TaN films with different N2 partial pressure were deposited on 304 stainless steel using the magnetron sputtering method. The effect of gas pressure on the mechanical property, morphology and phase structure of the films is investigated by X-ray diffraction (XRD), atomic force microscopy (AFM), microhardness testing, friction coefficient measurements, and wear mechanism study. The XRD results c...

in this study carburizing and boronizing processes were applied to powder metallurgy steel specimens and the mechanical and tribological properties of the substrate and coatings were evaluated under various process conditions. the specimens, made from industrial test pieces, were carburized in a powder pack for a duration of 2-5 hrs at 850-950 ˚c. similar specimens were pack boronized for 4 hrs...

This article presents the results of an experimental study which aimed to evaluate the effect of surface wear on the friction properties of geosynthetic interfaces constituted of geomembranes and geospacers. The tests were performed in ramp test device, and the results showed the different sensitivities of the interfaces to the wear process. For the particular types of interfaces considered in ...

Tribological properties of Ethylene-Propylene-Diene-rubber (EPDM) containing electron modified Polytetrafluoroethylene (PTFE) have been investiagted with the help of pin on disk tribometer without lubrication for a testing time of 2 hrs in atmospheric conditions at a sliding speed and applied normal load of 0.05 m·s–1 and FN = 1 N, respectively. Radiation-induced chemical changes in electron mo...

In this article, MC nylon/carbon nano tubes (CNTs) composites were prepared by in-situ polymerization method. The friction and wear properties were determined. The sample wear surface morphology carried out by scanning electron microscope (SEM) and the wear mechanism was investigated. It was found that the friction coefficient of composites has decreased with the amount of CNTs increasing in th...

The wear properties of biomaterials have been demonstrated to have a high importance within orthopedic bearing surfaces. This study performed a comparison of the wear between the two main grades of Ultra High Molecular Weight Polyethylene types GUR 1020 and GUR 1050 articulating against Cobalt Chromium. Such a high capacity wear comparison has not been reported elsewhere in the scientific liter...

In the present article, the thermal analysis of the cylinder and the piston in four-cylinder engines, made of functionally graded materials (FGMs), has been performed by using the super element method. The objective of using FGMs in the cylinder and the piston is to increase their performance. FGMs include a combination of ceramics and metals. Inside the cylinder, the ceramic is considered and ...

The present requirement of automobile industry is seeking lightweight material that satisfices the technical and technological requirements with better mechanical and tribological characteristics.  Aluminium matrix composite ( AMC ) materials meet the requirements of the modern demands. AMCs are used in automotive applications as engine cylinders, pistons, disc and drum brakes. This paper inves...