Context. High levels of deuterium fractionation in gas-phase molecules are usually associated with cold regions, such as prestellar cores. Significant fractionation ratios are also observed in hot environments such as hot cores or hot corinos, where they are believed to be produced by the evaporation of the icy mantles surrounding dust grains, and are thus remnants of a previous cold (either ga...

chamran 2 cultivar with the pedigree attila 50y//attila/bacanora, originated from national cereal breeding program by crossing between chamran cultivar and  attila line in karaj (1996-97). the f1 plants were evaluated and selected in 1997-98 cropping season. the new cultivar was evaluated in six warm and dry southern research stations of the country (2004-2006). chamran cultivar with good adapt...

Abstract. In an ongoing quest to realize lighter vehicles with improved fuel efficiency, deformation characteristics of the material AA 6016 is investigated. In the first part of this study, material behavior of Al–Mg–Si sheet alloy is investigated under different process (temperature and strain rate) and loading (uniaxial and biaxial) conditions experimentally. Later, warm cylindrical cup deep...

Distortion or bend in a turbine rotor (especially HIP rotors) may be caused by a number of factors, either singularly or in combination. In general, the causes of rotor bend can be classified invariably in two categories: Rapidly forming permanent rotor bends and/or Slower forming rotor bends, which could trip the turbines’ emergency stop. One of the major modifying solutions for rapid repairin...

Aluminum alloys have a high strength-to-weight ratio and proper anti-corrosion properties that are used in the automotive, shipbuilding and aerospace industries. The major problem with forming aluminum sheets is the low formability of aluminum sheets at room temperature. Therefore, in the present study, warm deep drawing (WDD) of AA5052-O aluminum alloy sheets with a thickness of 1mm was invest...

shape error due to elastic recovery of formed part in unloading known as springback, is one of the most important problems of tool design in sheet metal forming processes. many researches have been performed for proposing an efficient method to decrease or compensate springback error in sheet forming processes. these methods are usually based on iterative finite element algorithms. in this pape...

We present the case report of a 13-month-old Caucasian toddler with symptoms of loss of consciousness, central cyanosis and uncontrolled movements of the upper limbs while taking a warm bath. The diagnosis of hot water epilepsy was supported by an ictal EEG. Hot water epilepsy, also known as bathing epilepsy or water-immersion epilepsy is, in the Caucasian population, a rare form of benign epil...