Artificial neural networks are one of the modern methods of the production optimisation. An attempt to apply neural networks for controlling the quality of bentonite moulding sands is presented in this paper. This is the assessment method of sands suitability by means of detecting correlations between their individual parameters. This paper presents the next part of the study on usefulness of a...

S. Żymankowska-Kumon, AGH University of Science and Technology, Kraków, Poland The article contains the results of emission BTEX (benzene, toluene, ethylobenzene and xylenes) during thermal destruction (500 – 1 300 °C) of moulding sand with furan resin. This furan resin is with a high content of free furfuryl alcohol (about 80 %). Knowledge of emissions of these compounds allows the assessment ...

In the present work, novel Ultra-high molecular weight polyethylene (UHMWPE) composites reinforced with 3wt. %, 6wt. %, 9wt. %, 12wt. % and 15wt. % PEEK particles are fabricated by using hot compression moulding technique and mechanical properties are investigated. Experiments were conducted as per ASTM standards to evaluate the properties of tensile, flexural, impact, and microhardness. The re...

In this investigation, studies are carried out on the mechanical properties of hybrid polymer composites. Hybrid composites can reach a better combination of both artificial and natural fibre properties. Different weight percentages of jute fibres were hybridised with coconut sheath to produce the composites through compression moulding. Composites were produced using untreated and treated fibr...

Orally disintegrating tablets (ODTs), also known as fast melts, quick melts, fast disintegrating and orodispersible systems, have the unique property of disintegrating in the mouth in seconds without chewing and the need of water and are thus assumed to improve patient compliance. Conventional methods like direct compression, wet granulation, moulding, spray-drying, freeze-drying and sublimatio...

During hot seasons the inlet temperature of Nitrogen increases, as a result compressor consumes more power for compressing a specific mass ratio of fluid and consequently total energy consumption of the compressor increases as well. In this research, a three stage centrifugal compressor with intercooler was modeled thermodynamically in order to decreases the energy consumption of the compressor...

Although much progress has been made in the computation of Eulerian steady flows with high viscoelasticity, less work has been done for the case of transient flows. Because of their importance in injection moulding, blow moulding and other forming processes, as well as their intrinsic interest, we believe more attention should be focussed in this area. Hence in this paper we review progress in ...

Optimization is necessary for the control of any process to achieve better product quality, high productivity with low cost. The beltline moulding process is difficult task due to its low defects, making the material sensitive to reject. The efficient beltline moulding process involves the optimal selection of operating parameters to maximize the number of production while maintaining the requi...

D. Nowak, K. Granat, B. Opyd, Wroclaw University of Technology, Department of Foundry Engineering and Automation, Wrocław, Poland In the paper, presented are results of a research on influence of compaction degree on dielectric properties of components of moulding sands. During recent years, intensive research works on possibilities of using microwave heating in foundry technique are carried-ou...