In this study, carbon nano fibers (CNFs) were mixed into epoxy resin through a magnetic stirrer and again mixed using ultra sonicator. Using hand layup technique, biaxial braided fiber composites were prepared with unfilled, 0.2, 0.5 and 1 wt% CNF. Tensile test and shear test was performed to identify the tensile strength and shear strength of the composites. Fractured surface of the tensile sp...

In Malaysia, there is no research done on the tensile strength of structural size timber. The tension stress found in the Malaysian code of practice, MS 544: Part 2: 2001, was not determined directly and it was taken as 60% of the bending strength values of small clear specimens. This paper presents the results of the tensile test on structural size timber specimens from selected Malaysian Trop...

background and aims. polymethyl methacrylate (pmma) is widely used for the fabrication of removable prostheses. silver nano-particles (agnps) have been added to pmma because of their antimicrobial properties, but their effect on the mechanical properties of pmma is unknown. the aim of this study was to investigate the effects of agnps on the tensile strength of pmma. materials and methods. for ...

objective: the aim of the present study was to compare microtensile bond strengths (μtbs) of glass fiber posts to different parts of intra-radicular dentin using conventional method and one-shot technique under different light intensities. materials and methods: twenty-eight single-rooted teeth were prepared to receive fiber posts: group 1: conventional method at light intensity of 600 mw/cm2; ...

Cellulose crystals (CC) were chemically derived from jute by alkali treatment, bleaching and subsequent hydrolysis with 40 % sulfuric acid. Infrared spectroscopy (FT-IR) suggested sufficient removal of lignin and hemicellulose from the raw jute and scanning electron microscopy (SEM), and X-ray diffraction (XRD) studies demonstrated the preparation of microcrystalline cellulose. CC reinforced po...

The project aims to study tensile softening behavior of fiber reinforced concrete .Concrete is very much weak in tension but by addition of randomly oriented short crimped steel fibers will change the behavior from brittle to ductile. In the present work, the steel fibers were added at the volume fraction, being 0%, 0.5%, 1%, 1.5% to the normal strength concrete and high strength concrete. The ...

background and aims. polymethyl methacrylate, pmma, is widely used in prosthodontics for fabrication of removable prostheses. this study was undertaken to investigate the effect of adding silver nanoparticles (agnps) to pmma at 2% and 0.2% concentrations on compressive and tensile strengths of pmma. materials and methods. the silver nanoparticles were mixed with heat-cured acrylic resin in an a...

background and aims. although microwave irradiation has been used for disinfection of dental stone casts, there are concerns regarding mechanical damage to casts during the process. the aim of this study was to evaluate the effect of microwave irradiation on the compressive strength (cs) and diametral tensile strength (dts) of stone casts. materials and methods. in this in vitro study, 80 cylin...

Rapid heat cycle molding (RHCM) is a special molding process capable of producing molded plastic parts with high surface quality and improved weldline strength and appearance. This study investigated the influence of the weldline on the tensile strength of RHCM and conventional injection molded (CIM) components. The test specimens with and without a weldline were cut from RHCM and CIM parts for...

It is commonly proposed that the fatigue strength can be enhanced by increasing the tensile strength, but this conclusion needs to be reconsidered according to our study. Here a recrystallized α-Cu-15at.%Al alloy with moderate grain size of 0.62 μm was fabricated by cold rolling and annealing, and this alloy achieved exceptional high fatigue strength of 280 MPa at 10(7) cycles. This value is mu...