This life cycle design (LCD) project was a collaborative effort between the National Pollution Prevention Center at the University of Michigan, General Motors (GM), and the U.S. Environmental Protection Agency (EPA). The primary objective of this project was to apply life cycle design tools to guide the improvement of fuel tank systems. Two alternative fuel tank systems used in a 1996 GM vehicl...

The objectives of this study were to measure the Furcation Entrance Dimensions of first and second permanent molars in Malaysian samples and to compare the Furcation Entrance Dimensions with the blade widths of periodontal Gracey’s curette used for root surface instrumentation. A total of 199 extracted permanent teeth were measured, which comprised of 51 mandibular first molars, 51 mandibular s...

the directional response and roll stability characteristics of a partly filled tractor semi-trailer vehicle, with cylindrical tank, are investigated in various maneuvers. the dynamic interaction of liquid cargo with the tractor semi-trailer vehicle is also evaluated by integrating a dynamic slosh model of the partly filled tank with five-degrees-of-freedom of a tractor semi-trailer tank model. ...

The subject of petroleum storage tank fires has gained a great deal of attention due to the high cost of petroleum, and the consequent disruption of petroleum production; therefore, much of the current research has focused on petroleum storage tank fires. Also, the number of petroleum tank fires is oscillating between 15 and 20 fires per year. About 33% of all tank fires are attributed to light...

The inspection of a storage tank floor is a time consuming and expensive procedure, mainly due to necessity to empty and to clean the tank before an inspection. For this purpose a long range ultrasonic technique based on Lamb waves may be applied. Such an approach is used for inspection of pipes and can cover the distances up 100m. However the storage tanks are much more complicated structures ...

Original scientific paper This paper presents designing of spherical tank using combination of analytical procedure with FEM analysis and experimental testing in order to minimize design time and verify design strength. Analytical procedure for calculation of the tank strength in the initial stages of design process is briefly presented. Based on analytical results, tank is dimensioned and FEM ...

Thermodynamic analysis and numerical modeling of hurricane intensity has shown that its is controlled by the enthalpy transfer from the ocean surface and by drag. Direct measurements of drag, evaporation, and sensible heat transfer are not easily performed on the high seas. Therefore, a wind wave tank has been constructed in which a few aspects of a tropical storm are simulated. The air velocit...