Traditional cascade multilevel inverter can only transmit one-direction of energy. This paper proposes a new cascade multilevel inverter topology and control strategy based on part units to realize the energy feedback. By using PWM converter to replace uncontrollable converter in part units of the traditional inverter, and combining the inverter with H-bridge inverter, the two-direction running...

In this paper, a series Z-source inverter based on switched inductors cell is proposed for the first time. This inverter is able to increase the voltage gain in comparison to the conventional Z–source inverters in additon to solve the ST (shoot-through) state’s problems. In this inverter, the value of voltage gain is increased by increasing the number of used diodes and inductors in the switche...

In thispaper comparative performance analysis of MOSFET based& IGBT based single phase inverter has been evaluted. The paper compares overall THD of output voltage of thesetwoproposedinverters. Heresinusiodal PWM scheme has been usedwhich compares a sinusoidalreference voltage with a carrier basedmodulating signal to generategating pulse for inverter circuit. Power quality of inverter output vo...

Multilevel voltage source inverter has been recognized as an important alternative to the normal two level voltage source inverter, especially in high power application. Using multilevel technique, the output voltage amplitude is increased, switching devices stress is reduced and the overall harmonics profile is improved. Three presentable topologies can b considered for multilevel inverter (ML...

The phase synchronous inverter is an electrical inverter device which is synchronizing inverter phase with the micro-grid phase. Generally, DC voltage supply is considered as the input of the DC to AC inverter which is a renewable energy source such as solar panel, wind turbine and battery storage, etc. The three phase three layer phase synchronous inverters are normally utilized in the high po...

A soft-switched inverter is derived from the passively clamped quasi-resonant link circuit with three different clamps: coupled inductor, diode clamp and coupled inductor and capacitor. The proposed soft-switching inverter is formed from the traditional pulse-width modulated (PWM) inverter by simply augmenting with auxiliary resonant circuits, and the soft switching is achieved through applying...

This paper presents an active solution to a commonmode voltage created by typical three-phase inverters. It is shown that the addition of a fourth leg to the bridge of a threephase inverter eliminates the common-mode voltage to ground created by the modulation of the inverter. An appropriate fourphase LC filter is inserted between the inverter and the load in order to create sinusoidal output l...

This paper proposes a generalized space vector pulse width modulation (SVPWM) technique for hybrid multilevel inverters for minimizing total harmonic distortion (THD). The proposed method easily determines the actual location of the instantaneous reference space vector and the corresponding switching sequence of a multilevel inverter. The proposed algorithm offers a novel method for minimizing ...

In high power high voltage application BLDC motor are widely used because of high efficiency, simple construction, low cost less maintenance and high torque or high output power per unit volume. For driving the BLDC motor we required inverter. PWM inverter which gives good performance. In two level inverter there is a problem of harmonics distortion, lower electromagnetic interference, high DC ...

The role of multilevel inverters in improving power quality has been already proved long back ago. The major concern in using multi level inverters is the number of switches used in it. As the level of inverter increases. So there is a need to reduce the component count in multilevel inverter. In this paper we use a statcom which is consists of a multilevel inverter with reduced switch count. T...