نتایج جستجو برای: strain energy release rate serr
تعداد نتایج: 1932433 فیلتر نتایج به سال:
Aims and background: Trigger points are sensitive points in the skeletal muscle and neck muscles that cause referral pain, decrease the range of motion and muscle soreness. Therefore, the purpose of this study was to compare the effect of the Positional Release Technique with and without strain-counter strain technique on the pain, neck range of motion in men with active trigger points in uppe...
The relationship among complement consumption, C3 deposition, and C3 fragmentation pattern was compared for serum-sensitive (Sers) and serum-resistant (Serr) strains of Pseudomonas aeruginosa. The Sers strains, which were mucoid strains derived from patients with cystic fibrosis, had lipopolysaccharide deficient in O-antigen side chains. These organisms generally activated much less complement ...
background recently, assessment of the atrial motion and deformation indices obtained via doppler myocardial imaging (dmi) has been proposed as a new method of exploring the atrial function. objective our aim was to assess the right atrial (ra) regional function using myocardial velocities, strain, and strain rate imaging (sri) and compare it with the function of the inter-atrial septum (ias) a...
in this paper, the mean value of strain energy density criterion has been used to predict the critical fracture load in specimens with u-shaped notch under bending loads. an equation for calculation of averaged strain energy density in this zone has been presented. bending loads under mode i have been considered. two cases have been studied: 1) the control volume only includes the semicircular ...
This article discusses results obtained from a parametric study to analytically evaluate the impingement of a crack at the interface of an environmental barrier coating (EBC) and a monolithic Silicon nitride (Si 3 N 4) layered ceramics substrate. The study establishes a correlation that leads to determine if the crack is arrested or advanced by either penetrating or deflecting along the EBC/sub...
In this research, the hot deformation behavior of W360 tool steel was investigated using hot compression test at 1000-1200°C and strain rates of 0.001, 0.01, 0.1, and 1 s-1. According to the results, dynamic recrystallization was found the most important restoration factor of this alloy during hot deformation. Recrystallization was enhanced with an increase in temperature and strain rate. Also,...
نمودار تعداد نتایج جستجو در هر سال
با کلیک روی نمودار نتایج را به سال انتشار فیلتر کنید